Philco Model 81-need help please - Printable Version

+- The PHILCO Phorum (https://philcoradio.com/phorum)
+-- Forum: Philco Radio Discussions (https://philcoradio.com/phorum/forumdisplay.php?fid=5)
+--- Forum: Philco Electronic Restoration (https://philcoradio.com/phorum/forumdisplay.php?fid=8)
+--- Thread: Philco Model 81-need help please (/showthread.php?tid=11733)

---

RE: Philco Model 81-need help please - morzh - 03-03-2015

House GND is the Earth GND.
A waterpipe is a good one.

Or the GND pin in the power outlet.

---

RE: Philco Model 81-need help please - Jay Thomas - 03-03-2015

(03-03-2015, 05:11 PM)Radioroslyn Wrote:  Earth ground is best. Shouldn't blow gfi or breaker unless the cap that from the ac line to the chassis is bad.
Terry

Thanks Terry.

---

RE: Philco Model 81-need help please - Jay Thomas - 03-10-2015

(03-02-2015, 03:08 PM)Jay Thomas Wrote:  

(03-02-2015, 01:34 PM)Bill Bacco Wrote:  If you are interested in some changes I made to my 81 Jr to address the volume issue, check out the following thread.

http://philcoradio.com/phorum/showthread.php?tid=6135&pid=38812#pid38812

Bill

Thanks Bill.  May be the next thing I will try.  This seems to put the volume control in the output circuit where later models have them. 

Jay

Hi Bill:

I made the changes in your diagram to my delight!  Grounding the receiver was not an option for me.  With the circuitry change I can now control the volume from zero to loud on the strongest stations.  I do not notice any distortion at any volume level and I now receive more stations than I did before the changes.  Amazing!  Thanks much!

Jay

---

RE: Philco Model 81-need help please - Radioroslyn - 03-10-2015

If you would like to raise the sensitivity that 1.2k resistor seem a bit low unless you have a 50,000w AM blowtorch near. The original was 20k. I'd play with that value. Try  5,10,15K. If you live in stickville you can just remove that resistor.
Terry

---