Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Asbestos in philco TV
#1

I have a 51-T1601 and a friend told me to look for Asbestos in old electronics does anyone know if this model has Asbestos in it?
#2

If it is there (it is present in portable tube radios like Zenith Transoceanic) you will see it. It is typically a sheet asbestos.
They scare people with it, but it is a danger wben you constantly encounter it or get into a demolition of something containing it...in other words it is not volatile and if you do not decide to drill it, rub it, vacuum it, run around waving it, it won't hurt you. Somehow mesothelioma is not very much present in general population from 20s to 80s when the dangers were not studied and it was widely used in electrical devices, from the radios and soldering irons to household irons. And changing the heating element in the iron was the man of the house' job.

You shouldn't sniff it. This is about it.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#3

 I don't know the particulars of this model of Philco TV but if they used any it would be the greyish-white cardboard type and it would be in the top or on the inner side of the cabinet, not under the chassis, if there is any you will see it straight away, it would not be hidden anywhere. Typically TV sets either had a metal screen or slats in the cabinet under the chassis to aid in ventilation rather then an asbestos sheet. Come to think of it in most TVs there was enough air space above the chassis, thanks to the cabinet also housing the picture tube, that I don't think that they needed an asbestos sheet in the top of the cabinet either.
 The fellow to ask about asbestos in early Philco TV sets would be Bob Andersen, he owns several of them. However as Mike mentioned there are a  lot of unnecessary hysterics about asbestos, the way people go on about it you would think that just looking at it crosseyed would turn one into a cancer ridden lump. First of all the kind of asbestos used in radios and other appliances was chrysotile based, which is the least hazardous variety. Second, unless you disturb it, as in grinding it up, putting you nose up against it and snorting it, it is not going to cause you any health problems. As a matter of fact you probably stand a better chance of inhaling asbestos fibers when you go for a drive or a walk, they used to use asbestos in brake linings in car and truck drum brakes. Also in some areas asbestos fibers enter the atmosphere from natural sources, like from cliffs and bluffs through erosion, it did come out of the ground originally after all. 
 But if you are wondering what to do about an asbestos sheet should you run across some you have a few options. If it's in good condition leave it alone, or if it worries you you can seal it with something like latex paint to encapsulate it. If it is coming apart you can spray it with water, remove the staples holding the sheet in, put it in a plastic bag, and chuck it in the garbage. But stay safe, remember to look both ways before crossing the street, and no texting whilst driving either, both of those activities are several thousand times more dangerous then asbestos in a radio or tv.
Regards
Arran




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
The list of my radio & TV collection!
Hello Peter, Thank you for posting that !! Sincerely Richardradiorich — 09:40 AM
Eico 232 VTVM Schematic
It's a microwave antenna. ?;-p?. I substituted 1N4002s off the 6.3 vac winding for the 1.5 volt battery. Uniprobe is the...RodB — 05:50 PM
Eico 232 VTVM Schematic
Try BAMA for a schematic. Looks like a replacement power source for the D battery has been installed. The tube may be...Chas — 04:51 PM
Eico 232 VTVM Schematic
Is that a battery holder?morzh — 04:43 PM
Eico 232 VTVM Schematic
A friend gave me this Eico 232 VTVM and I'm having trouble locating the schematic for it. This one seems to be a later v...RodB — 04:17 PM
Var resistor id
Considering what it is in series with, I doubt there should be any power requirements. Of course, we should know wher...morzh — 03:23 PM
Var resistor id
Trim pot, about 1/2 watt part of focus divider. As stated 2k ohms. This appears to be a rusty chassis, resolder all ...Chas — 03:19 PM
Var resistor id
Its a Sylvania 400 oscilloscope. here is a clip of r-100. Would be nice to know the current required. Not listed in part...Martinj — 02:10 PM
The list of my radio & TV collection!
Thanks Richard. I hope you enjoy it. Here I have created an English section on the history of radio with videos in Engl...RadioSvit — 10:23 AM
The list of my radio & TV collection!
Hello RadioSvit, first all happy new year ! I will watch your new videos this week. Sincerely Richardradiorich — 09:19 AM

[-]
Who's Online
There are currently 6006 online users. [Complete List]
» 1 Member(s) | 6005 Guest(s)
Avatar

>