Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Dragged in another postwar Zenith.
#1

A co-worker and friend of mine talked to me a few days ago and wondered if I wanted a Zenith conole radio he had gotten cheap at a junk auction. Said he had been listening to FM on it without much issue. I went to visit him today and found it to be a decent little radio-phono console from the early 50's. Has an 8H20 chassis in it with the variable speed phonograph that I find to be neat. A little cash later and it was coming home. Other than the odd dial light being burnt out and a dirty band switch, it seemed to work fine on the radio. I pulled the chassis to clean up the switches and get the worst of the dirt blown off, only to find the one oil ringer cap near the power switch was blown clear in half! So, it will be getting recapped in the future. Kind of a shame as it was working rather well in spite of the bad cap. Cabinet is good except the top. Back top veneer is messed up. It should be worth a few extra dollars to put the insides right. I'll get some pictures of it once it is back together.

No matter where you go, there you are.




Users browsing this thread:
[-]
Recent Posts
6TPZ and 5TPO Radio Help
Welcome to the Phorum, R3Sons! I have very limited experience with car radios other than installing custom radios back ...GarySP — 01:08 PM
462ron
OK, I need to rename this thread to say..Eico 368 TV/FM Sweep Generator instead of the current title..Heathkit Sweep Gen...462ron — 12:49 PM
6TPZ and 5TPO Radio Help
Hello, I have a Philco (Ford) 6TPZ and a 5TPO radio.  I replaced the electrolytic capacitors in both.  I have the SAMS m...R3Sons — 12:29 PM
The list of my radio & TV collection!
Hello Peter, Thank you for posting that !! Sincerely Richardradiorich — 09:40 AM
Eico 232 VTVM Schematic
It's a microwave antenna. ?;-p?. I substituted 1N4002s off the 6.3 vac winding for the 1.5 volt battery. Uniprobe is the...RodB — 05:50 PM
Eico 232 VTVM Schematic
Try BAMA for a schematic. Looks like a replacement power source for the D battery has been installed. The tube may be...Chas — 04:51 PM
Eico 232 VTVM Schematic
Is that a battery holder?morzh — 04:43 PM
Eico 232 VTVM Schematic
A friend gave me this Eico 232 VTVM and I'm having trouble locating the schematic for it. This one seems to be a later v...RodB — 04:17 PM
Var resistor id
Considering what it is in series with, I doubt there should be any power requirements. Of course, we should know wher...morzh — 03:23 PM
Var resistor id
Trim pot, about 1/2 watt part of focus divider. As stated 2k ohms. This appears to be a rusty chassis, resolder all ...Chas — 03:19 PM

[-]
Who's Online
There are currently 8633 online users. [Complete List]
» 3 Member(s) | 8630 Guest(s)
AvatarAvatarAvatar

>