Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

BIG ZENITH 39A FINALLY FINISHED
#1

    This zenith gave me goose bumps after I completed putting back together because I am so proud of all the hard work that I have put into this and the results are stunning. It plays very nice , it is a show piece.


Attached Files Image(s)
                   
#2

Here are a few more pictures of the zenith.


Attached Files Image(s)
                   
#3

beautifully done  fred  like it with doors open Icon_clap Icon_clap Icon_thumbup
what is lever under speaker grill ?
sam

Some day, and that day may never come, I will call upon you to do a service for me. But until that day, accept this justice as a gift
mafiamen2
#4

Gee Wizz Fred you always seem to amaze us! All I can say is WOW. That set came out beautiful. Great job I simply love it!  Icon_clap  
#5

Very nice Fred!
Icon_clap Icon_clap Icon_clap
#6

It is beautiful. Icon_thumbup You do good work.

--
Ron Ramirez
Ferdinand IN
#7

(03-20-2015, 04:00 AM)sam Wrote:  beautifully done  fred  like it with doors open Icon_clap Icon_clap Icon_thumbup
what is lever under speaker grill ?
sam

 The lever will rotate the large loop antenna that's on the inside of cabinet, you can see that antenna in one of the pictures of the back, its in the left coner.
#8

Looks great, could be a centerpiece.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#9

Fred, you do just terrific work. Lovely radio.
Jerry

A friend in need is a pest!  Bill Slee ca 1970.
#10

With the Philco on top. as it should be, the Zenith is stellar.

Paul

Tubetalk1
#11

Excellent! One of the best restorations I've seen yet. Hats off to you, Fred.

Slave to an RCA Victor CTC-25
#12

   I can see that this one took a lot of work.. Hats off to  you and your ability to make it look  the way it does now.
       It  looks very good.
#13

Wow, it's beautiful!

Steve

M R Radios   C M Tubes




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
An attempt to remove the Field Coil from a G speaker
Gary I in fact did, on a 38-14, I think, where I had a speaker with the dead coil. Well...it kinda worked. Kinda, be...morzh — 10:38 PM
An attempt to remove the Field Coil from a G speaker
Mike, what ever happened to that plan you had to try using a rare earth magnet to magnetize the pole? This looks like a...GarySP — 10:25 PM
RCA T62 is playing.....
Beautiful set.morzh — 09:07 PM
An attempt to remove the Field Coil from a G speaker
Well....here it is. The green stuff. Unfortunately, probably penetrates deep. I opened the top layer and saw that: ...morzh — 08:58 PM
Philco 91 Restore Code ??
:clap: :clap: :clap: :clap: Really nice workmanship!!! Top of the chassis looks great. Sorry about the long winded e...MrFixr55 — 08:09 PM
Philco 40-120C Restoration
Thank you for your reply. I will check voltages on the other tubes, look at resistor 23 and cap 25, etc. If all else fai...bluecap — 07:58 PM
RCA T62 is playing.....
Nice looking set great save. DavidDavid — 07:48 PM
Philco 89 indicator light.
Hello Jim, I have done several 89s. The trick is to move the drum in or out on it's shaft. You will need to loosen a set...dconant — 07:36 PM
An attempt to remove the Field Coil from a G speaker
MrFixr Yes, it is my plan to go with 45rpm spider if I go that far. No, the pole was not left-handed as I unscrewed ...morzh — 07:14 PM
Philco 40-120C Restoration
Change the tube. Check the tube's bias network. Are any other tubes experience the drop or just this?` Is resistor 23 OK...morzh — 07:09 PM

[-]
Who's Online
There are currently 7164 online users. [Complete List]
» 1 Member(s) | 7163 Guest(s)
Avatar

>