1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
repairing light sockets
murf
Senior Member
****
Posts: 669
Threads: 145
Joined: Jun 2011
City: Elko,MN.
#1

02-06-2016, 01:05 PM
Hi Guy's,
I know I have read a n article Ron put on here about repairing Philco light sockets, but I can't find it.
I have a 37-116 that I need to replace or repair light sockets on.
Mine is missing the original light sockets and wire harness.
I managed to find a couple light sockets with the shields that need to be re-built.
Can someone supply me with a link?
Thanks,
murf
Find
KCMike
Phorum Expert
*****
Posts: 1,475
Threads: 69
Joined: Nov 2012
City: Kansas city, MO.
#2

02-06-2016, 01:15 PM
Philcoradio.com - Tech Section - Pilot Lamp Rebuilding
Couldn't post clickable link.
(This post was last modified: 02-06-2016, 01:17 PM by KCMike.)
Find
sam
Phorum Expert
*****
Posts: 2,573
Threads: 337
Joined: Jun 2013
City: lawrenceville nj
#3

02-06-2016, 01:16 PM
here
http://www.philcoradio.com/tech/lamps.htm

sam
Some day, and that day may never come, I will call upon you to do a service for me. But until that day, accept this justice as a gift
mafiamen2
Find
murf
Senior Member
****
Posts: 669
Threads: 145
Joined: Jun 2011
City: Elko,MN.
#4

02-06-2016, 01:48 PM
(02-06-2016, 01:16 PM)sam Wrote:  here
http://www.philcoradio.com/tech/lamps.htm

sam

Thanks Sam and Mike.
murf
Find
Arran
Phorum Expert
*****
Posts: 4,804
Threads: 54
Joined: Sep 2008
City: Sandwick, BC, CA
#5

02-06-2016, 11:23 PM
  If you could find some phenolic or porcelain washers of a suitable size that would be an improvement over the nylon ones, although all are better then the rubber crap Philco used.
Regards
Arran
Find
« Next Oldest | Next Newest »
Thread Closed




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
462ron
Hi Levi, here’s just a thought. Most radios run the oscillator higher than the dial setting. Say you set your radio to 1...462ron — 10:10 AM
1930s Stewart-Warner Tombstone Radio need help identifying model number
Another Update: I found a couple of damaged coils inside this radio that might have something to do with why this radio ...captainclock1988 — 10:51 PM
6TPZ and 5TPO Radio Help
If you are still on 5TPO, you lost me there. What X7? What Points 1 and 2?morzh — 08:37 PM
6TPZ and 5TPO Radio Help
Quick progress report: X7 is broken. Only one leg soldered, the other missing and the diode is cracked. I've replaced...R3Sons — 05:05 PM
6TPZ and 5TPO Radio Help
Oh...and you have electrolytic caps there. All need to go and be replaced.morzh — 04:36 PM
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM

[-]
Who's Online
There are currently 4292 online users. [Complete List]
» 1 Member(s) | 4291 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration