Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Tube bloat in an RCA?
#16

Looking through Beitman's early Crosley sets, the ones with the most bloat and convoluted circuitry I think I've ever seen are the model 160 and 171, each with 12 tubes.
#17

Well, I seem to be in a major holding pattern on this radio and a few other deals, including three radios I am trying to sell. Might end up having to throw in the towel and persue other interests for a bit.

No matter where you go, there you are.
#18

I have seen several Crosleys I have thought were aesthetically pleasing to view but have not had the confidence in the innards to go for it. I have to keep looking. If the tube set up does seriously contribute to performance why bother. Like those old ads, "6 tubes provide 8 tube performance" they said that to think you were getting a hot set. On the other hand just cause a set has 10 tubes it can still be a clunker.

Paul

Tubetalk1
#19

The D-22 is quite a set!

One thing I have always wondered about is why resort to a 2V tube when there were very good 6V tubes available?

Both the 6A3 and 6B4G are considered equivalent to the 2A3 in the RCA RC-17 manual.
Additionally, 6L6 tubes were available.




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM
RCA 15X
I'd try replacing the bulb first and if that doesn't do it, then change the 35Z5 and see if the problem goes away.NostalgiaRadioTime — 12:28 AM
B&K 1077B no video
Hello Tim, I have that exact unit in my shop too plus a Sencore unit there are times I like one or other !!. Sincerely...radiorich — 11:07 PM
RCA 15X
Everthing goes at once, maybe it's the cold weather, I have had 2 dial strings break and no my little RCA is having dial...Paul Philco322 — 10:26 PM
Philco 91 Schematic
Hi Dan, I can't explain this specific resistor but I have seen the use of a switch to apply B+ voltage to screen gri...RodB — 09:36 PM
6TPZ and 5TPO Radio Help
I suspect it's been repaired before. And I suspect whoever repaired it, wanted to re-use old transistors' pin stubs in o...morzh — 09:24 PM

[-]
Who's Online
There are currently 7096 online users. [Complete List]
» 1 Member(s) | 7095 Guest(s)
Avatar

>