Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Changed caps in a 40-190
#1

Soooo I finally got around to replacing the caps in my 40-190. Got orange dips from just radios.com. A lot of the stations sound great (850,1420,1100) and more. But on some I always get a low static even on some of the higher stations. Could it need a resistor replacement or just bad signal since I live on the ground floor in a condo?

AJ
#2

Easy to check for interference. Take it outside and try it. Plug it into a different circuit, etc. If that doesn't fix it, make sure the tuning cap is clean. Dust between the plates can cause static. Resistors? I always check them when I am recapping. If you didn't, you can be sure that at least some of them have drifted in 73 years. I don't know if that would cause static though...

The artist formerly known as Puhpow! 8)
#3

Disconnect the antenna loop and turn up the volume. If the static is still heard when no stations are being received, then most likely it is being internally generated.

If you only hear the interference when the antenna is connected then it probably is from an external source. As PuhPow mentioned try taking it outside as far from the house or other wiring as possible and see if it is reduced.

A bad resistor or cap can make static noises, but the noise will be present also with the antenna disconnected and no signal being received.




Users browsing this thread:
[-]
Recent Posts
Gloritone 27 Radio
I have a model 27 that someone painted the cabinet brown. I've been trying to sell it for awhile but the cabinet paint m...Jim Dutridge — 02:30 PM
Restoring Philco 96
Joseph Yeah. The situaction is complicated by me living with my family in NJ while mom is in FL. Were it not for my ...morzh — 10:55 AM
Restoring Philco 96
Best of wishes for your mother. I hope she recovers well. My mother struggles with sciatic pain as well, so I am familia...jrblasde — 10:41 AM
Restoring Philco 96
Well, because I am away, I cannot check it. Hope mom becomes better enough for me to get back. I think I will be here f...morzh — 10:27 AM
Restoring Philco 96
Nice find! I hope it completes your console.jrblasde — 08:45 AM
Gloritone 27 Radio
Hello john, That, is the first time I have have seen or heard of that brand and model. Welcome to the party !! Sincer...radiorich — 08:08 AM
370 Norman Bel Geddes trim pieces
Thank you! I’ll probably use the half-round molding and tone it to match the original. Thanks for the replies!Max T — 06:34 AM
Gloritone 27 Radio
I'm kind of late to this thread, but Buzz1151 has a 3 part restore series on the model 27: A little bit of extra t...Eliot Ness — 05:48 AM
370 Norman Bel Geddes trim pieces
You can get half-round moulding in various diameters at any home improvement store. That way the flat edge is uniform. ...GarySP — 12:03 AM
42-345 Resistors
Great comments. I have a tinkering bench at my office, and that's where Little Phil is right now. I will have to comb ...proftrussell — 11:12 PM

[-]
Who's Online
There are currently 1554 online users. [Complete List]
» 1 Member(s) | 1553 Guest(s)
Avatar

>