Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Made Garbage Cans!!!!
#1

This will look good in the radio museum.

[attachment=3728]

A good place to put used chewing gum and beer cans - yes?

[attachment=3729]

The smaller bottle says "Edison Battery Oil". I always thought that oil in your electrolyte was bad. Guess I'll have to start lubing my batteries.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#2

Oil in batteries was NOT in electrolyte - it was poured on TOP the electorlyte to prevent the evaporation.
#3

That isn't a garbage can, it's the glass case for a Philco battery. But I think you know that already, and are just kidding, right? ...right? Icon_wink

--
Ron Ramirez
Ferdinand IN
#4

Could be - - -

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#5

It does look a lot like a small kitchen trash can, doesn't it?

No matter where you go, there you are.




Users browsing this thread:
[-]
Recent Posts
6TPZ and 5TPO Radio Help
Welcome to the Phorum, R3Sons! I have very limited experience with car radios other than installing custom radios back ...GarySP — 01:08 PM
462ron
OK, I need to rename this thread to say..Eico 368 TV/FM Sweep Generator instead of the current title..Heathkit Sweep Gen...462ron — 12:49 PM
6TPZ and 5TPO Radio Help
Hello, I have a Philco (Ford) 6TPZ and a 5TPO radio.  I replaced the electrolytic capacitors in both.  I have the SAMS m...R3Sons — 12:29 PM
The list of my radio & TV collection!
Hello Peter, Thank you for posting that !! Sincerely Richardradiorich — 09:40 AM
Eico 232 VTVM Schematic
It's a microwave antenna. ?;-p?. I substituted 1N4002s off the 6.3 vac winding for the 1.5 volt battery. Uniprobe is the...RodB — 05:50 PM
Eico 232 VTVM Schematic
Try BAMA for a schematic. Looks like a replacement power source for the D battery has been installed. The tube may be...Chas — 04:51 PM
Eico 232 VTVM Schematic
Is that a battery holder?morzh — 04:43 PM
Eico 232 VTVM Schematic
A friend gave me this Eico 232 VTVM and I'm having trouble locating the schematic for it. This one seems to be a later v...RodB — 04:17 PM
Var resistor id
Considering what it is in series with, I doubt there should be any power requirements. Of course, we should know wher...morzh — 03:23 PM
Var resistor id
Trim pot, about 1/2 watt part of focus divider. As stated 2k ohms. This appears to be a rusty chassis, resolder all ...Chas — 03:19 PM

[-]
Who's Online
There are currently 5820 online users. [Complete List]
» 1 Member(s) | 5819 Guest(s)
Avatar

>