Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 50-T702
#61

Yeah, the HV rectifier has been replaced. The HV is up where it should be about 5Kv. The picture is very viewable in a semi-dark room.

Crist
#62

Arran, that is interesting about the phosphor. I actually read about this recently in an old TV book. It mentioned that the phosphor can even degrade to the point that you can actually see into the tube from the front! Well, no matter if it is low emission or gas, the tube is tired. But, at least it is still giving service, and there is something to be said for that. Crist, that chassis is really looking nice! A little patience will pay off in locating a better tube. It took me over 30 years to find a NOS tube for one of my sets that I could afford. Mine had a line burned across the screen from a vertical sweep failure. That really wrecks an otherwise good picture! Icon_neutral

If I could find the place called "Somewhere", I could find "Anything" Icon_confused

Tim

Jesus cried out and said, "Whoever believes in me , believes not in me but in him who sent me" John 12:44
#63

(05-19-2016, 11:19 PM)Madmurdok Wrote:  Arran, that is interesting about the phosphor. I actually read about this recently in an old TV book. It mentioned that the phosphor can even degrade to the point that you can actually see into the tube from the front! Well, no matter if it is low emission or gas, the tube is tired. But, at least it is still giving service, and there is something to be said for that. Crist, that chassis is really looking nice! A little patience will pay off in locating a better tube. It took me over 30 years to find a NOS tube for one of my sets that I could afford. Mine had a line burned across the screen from a vertical sweep failure. That really wrecks an otherwise good picture! Icon_neutral

Yeah, I'm going to be patient.  Anybody have any knobs?

Crist
#64

 If you really can't stand watching a dim 7JP4 there are some scope tubes that will work as a cheap substitute, but the phosphors are P1 rather then P4, the drawback of course is that the phosphor is green rather then white. A lot of people go the scope tube route on one of those 3'' Pilot TVs since it's all too common to find one of the original 3KP4s with an open filament thanks to the goofy filament series string those sets used.
Regards
Arran
#65

Still looking for some knobs.

Crist




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-480 Electronic Restoration
I forgot to make mention of it the other day, but last week I corrected another error on my schematic (applies to both R...jrblasde — 09:27 PM
Gloritone 27 Radio
I have a model 27 that someone painted the cabinet brown. I've been trying to sell it for awhile but the cabinet paint m...Jim Dutridge — 02:30 PM
Restoring Philco 96
Joseph Yeah. The situaction is complicated by me living with my family in NJ while mom is in FL. Were it not for my ...morzh — 10:55 AM
Restoring Philco 96
Best of wishes for your mother. I hope she recovers well. My mother struggles with sciatic pain as well, so I am familia...jrblasde — 10:41 AM
Restoring Philco 96
Well, because I am away, I cannot check it. Hope mom becomes better enough for me to get back. I think I will be here f...morzh — 10:27 AM
Restoring Philco 96
Nice find! I hope it completes your console.jrblasde — 08:45 AM
Gloritone 27 Radio
Hello john, That, is the first time I have have seen or heard of that brand and model. Welcome to the party !! Sincer...radiorich — 08:08 AM
370 Norman Bel Geddes trim pieces
Thank you! I’ll probably use the half-round molding and tone it to match the original. Thanks for the replies!Max T — 06:34 AM
Gloritone 27 Radio
I'm kind of late to this thread, but Buzz1151 has a 3 part restore series on the model 27: A little bit of extra t...Eliot Ness — 05:48 AM
370 Norman Bel Geddes trim pieces
You can get half-round moulding in various diameters at any home improvement store. That way the flat edge is uniform. ...GarySP — 12:03 AM

[-]
Who's Online
There are currently 1565 online users. [Complete List]
» 1 Member(s) | 1564 Guest(s)
Avatar

>