Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco 46 200 code 122
#1

So I picked up this little Philco and I guess it is a different tube set than the more popular model. It uses 7A8 7B7 7C6 Tubes with the 35Z5 and 50L6GT. 

The schematic on Nostalgia Air has 14B6 14A7 7A8 tube. So I guess as tubes were a good deal, or overstock, etc......especially after the War there were several versions of set in similar cabinets. Maybe more of this on the cheaper sets.

Looking for a "freebie" schematic on my code 122 versions. Did some searches with no luck.

Any ideas?

Thanks.

Paul

Tubetalk1
#2

The 7xx series tubs were actually 6.3v, same as their 6xx octal brethren... Same for 14 volt actually 12.6... For awhile Sylvania did list the 7xx as 7v but that idea was shelved in either late 40s or early 50s...

Except for 7A8, the 7xx tubes should have same basing as 14xx so that schematic should be useable...

Tom
#3

Have a look here Paul might have the schematic you need. Good luck.
http://www.audiophool.com/Philco.html




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM
RCA 15X
I'd try replacing the bulb first and if that doesn't do it, then change the 35Z5 and see if the problem goes away.NostalgiaRadioTime — 12:28 AM
B&K 1077B no video
Hello Tim, I have that exact unit in my shop too plus a Sencore unit there are times I like one or other !!. Sincerely...radiorich — 11:07 PM
RCA 15X
Everthing goes at once, maybe it's the cold weather, I have had 2 dial strings break and no my little RCA is having dial...Paul Philco322 — 10:26 PM
Philco 91 Schematic
Hi Dan, I can't explain this specific resistor but I have seen the use of a switch to apply B+ voltage to screen gri...RodB — 09:36 PM

[-]
Who's Online
There are currently no members online.

>