Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

40-160 escutcheon
#1

I have recently acquired a 40-160 but the escutcheon covering the dial and 6 push buttons is missing. Does anyone know where I might possibly get these parts?
#2

jetmech7860 Wrote:I have recently acquired a 40-160 but the escutcheon covering the dial and 6 push buttons is missing. Does anyone know where I might possibly get these parts?

As far as I know the only source for these parts would be a parts set or parts salvaged from a parts set. You should be able to find the pushbuttons, as they are bakelite, but finding a good escutcheon may be a problem. The original escutcheons used on the 40-158, 40-160, and 40-165 consoles were made out of a type of plastic that has a habit of warping and cracking (some say it's Tenite) and as far as I know nobody is reproducing that style of escutcheon. Very likely the only thing you could do is to make a suitable facimile with either sheet brass, or plastic, or possibly wood. This is strange as most of the Philco models from 1940 used some form of brass escutcheon but these sets were the exception, the 1941 and 42 models were just the opposite with most escutcheons being made out of plastic.
Regards
Arran




Users browsing this thread:
[-]
Recent Posts
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM
RCA 15X
I'd try replacing the bulb first and if that doesn't do it, then change the 35Z5 and see if the problem goes away.NostalgiaRadioTime — 12:28 AM
B&K 1077B no video
Hello Tim, I have that exact unit in my shop too plus a Sencore unit there are times I like one or other !!. Sincerely...radiorich — 11:07 PM
RCA 15X
Everthing goes at once, maybe it's the cold weather, I have had 2 dial strings break and no my little RCA is having dial...Paul Philco322 — 10:26 PM
Philco 91 Schematic
Hi Dan, I can't explain this specific resistor but I have seen the use of a switch to apply B+ voltage to screen gri...RodB — 09:36 PM
6TPZ and 5TPO Radio Help
I suspect it's been repaired before. And I suspect whoever repaired it, wanted to re-use old transistors' pin stubs in o...morzh — 09:24 PM

[-]
Who's Online
There are currently 10312 online users. [Complete List]
» 4 Member(s) | 10308 Guest(s)
AvatarAvatarAvatarAvatar

>