Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 50-T702
#61

Yeah, the HV rectifier has been replaced. The HV is up where it should be about 5Kv. The picture is very viewable in a semi-dark room.

Crist
#62

Arran, that is interesting about the phosphor. I actually read about this recently in an old TV book. It mentioned that the phosphor can even degrade to the point that you can actually see into the tube from the front! Well, no matter if it is low emission or gas, the tube is tired. But, at least it is still giving service, and there is something to be said for that. Crist, that chassis is really looking nice! A little patience will pay off in locating a better tube. It took me over 30 years to find a NOS tube for one of my sets that I could afford. Mine had a line burned across the screen from a vertical sweep failure. That really wrecks an otherwise good picture! Icon_neutral

If I could find the place called "Somewhere", I could find "Anything" Icon_confused

Tim

Jesus cried out and said, "Whoever believes in me , believes not in me but in him who sent me" John 12:44
#63

(05-19-2016, 11:19 PM)Madmurdok Wrote:  Arran, that is interesting about the phosphor. I actually read about this recently in an old TV book. It mentioned that the phosphor can even degrade to the point that you can actually see into the tube from the front! Well, no matter if it is low emission or gas, the tube is tired. But, at least it is still giving service, and there is something to be said for that. Crist, that chassis is really looking nice! A little patience will pay off in locating a better tube. It took me over 30 years to find a NOS tube for one of my sets that I could afford. Mine had a line burned across the screen from a vertical sweep failure. That really wrecks an otherwise good picture! Icon_neutral

Yeah, I'm going to be patient.  Anybody have any knobs?

Crist
#64

 If you really can't stand watching a dim 7JP4 there are some scope tubes that will work as a cheap substitute, but the phosphors are P1 rather then P4, the drawback of course is that the phosphor is green rather then white. A lot of people go the scope tube route on one of those 3'' Pilot TVs since it's all too common to find one of the original 3KP4s with an open filament thanks to the goofy filament series string those sets used.
Regards
Arran
#65

Still looking for some knobs.

Crist




Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Eico 368 TV/FM Sweep Generator
Ron, for the future: In order to change the name of teh topic, 1. Go to the very first post. 2. Hit "Edit...morzh — 04:29 PM
6TPZ and 5TPO Radio Help
Transistors are easy. No converters. If you have input voltage, then just put some signal through. Or touch your fin...morzh — 04:25 PM
462ron
Hi Mike, I believe I tried different ways to change the header for my post but no luck. Anyway thanks for changing it fo...462ron — 04:02 PM
6TPZ and 5TPO Radio Help
Since these radios operated in harsh environments (temp changes and vibration) you could touch a soldering iron to all t...GarySP — 03:18 PM
6TPZ and 5TPO Radio Help
Thank you Gary. Hi Morzh. These radios are 6 transistor radios. Sadly no tubes. Thanks though.R3Sons — 02:19 PM
Heathkit Sweep Generator TS-4
Ron Instead of Quick reply, go to New Reply, then go to the title of the very first post, and change the title text the...morzh — 02:00 PM
6TPZ and 5TPO Radio Help
I am not a specialist in car radios. I suspect they might use vibrators to convert 12V to acceptable tube voltages, so ...morzh — 01:58 PM
6TPZ and 5TPO Radio Help
Welcome to the Phorum, R3Sons! I have very limited experience with car radios other than installing custom radios back ...GarySP — 01:08 PM
462ron
OK, I need to rename this thread to say..Eico 368 TV/FM Sweep Generator instead of the current title..Heathkit Sweep Gen...462ron — 12:49 PM
6TPZ and 5TPO Radio Help
Hello, I have a Philco (Ford) 6TPZ and a 5TPO radio.  I replaced the electrolytic capacitors in both.  I have the SAMS m...R3Sons — 12:29 PM

[-]
Who's Online
There are currently 9854 online users. [Complete List]
» 1 Member(s) | 9853 Guest(s)
Avatar

>