Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Cabinet rubber cushion replacement
#1

I am a new member.  I collect Philco radios as well as others.  While working on cabinets I'd like to replace old or missing rubber cushions on the bottom.  Any recommendations on web sites for sources?
#2

Hi and welcome!

Renovated Radios should be your first stop for these parts.

http://www.renovatedradios.com/parts.html

--
Ron Ramirez
Ferdinand IN
#3

Appreciate the guidance.  Thank you !!
#4

Welcome to the Phorum!
Icon_wave
#5

On the cabinet bottom or the chassis bottom? For the bottom of the cabinet you can find those in most hardware stores or home improvement centers, sometimes even dollar stores. For the corner cushions of Philco chassis Renovated Radios is one outlet, Radio Daze another, since it's a specialty item. If it's the generic large rubber washers there are a number of sources for those, AES has them, as does Radiodaze and Renovated Radios, other source might be McMaster-Carr or fleabay.
Regards
Arran
#6

Arran --- Thank you for the guidance. I actually need those under the cabinet and will check out HD or Ace. But appreciate the other recommendations also.

Cordially

Mike




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM
RCA 15X
I'd try replacing the bulb first and if that doesn't do it, then change the 35Z5 and see if the problem goes away.NostalgiaRadioTime — 12:28 AM
B&K 1077B no video
Hello Tim, I have that exact unit in my shop too plus a Sencore unit there are times I like one or other !!. Sincerely...radiorich — 11:07 PM
RCA 15X
Everthing goes at once, maybe it's the cold weather, I have had 2 dial strings break and no my little RCA is having dial...Paul Philco322 — 10:26 PM
Philco 91 Schematic
Hi Dan, I can't explain this specific resistor but I have seen the use of a switch to apply B+ voltage to screen gri...RodB — 09:36 PM
6TPZ and 5TPO Radio Help
I suspect it's been repaired before. And I suspect whoever repaired it, wanted to re-use old transistors' pin stubs in o...morzh — 09:24 PM

[-]
Who's Online
There are currently 8791 online users. [Complete List]
» 3 Member(s) | 8788 Guest(s)
AvatarAvatarAvatar

>