Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 650 decals
#1

A couple of questions about the 1936 Philco 650 console. I know it had the Philco decal, but did it originally have decals above the knobs? I don't see a set on Radio Daze. Mine is in the rebuild stage with the dial off for protection. Looking from the front, is the BC band extreme right? Thanks.
#2

Don't think I've ever seen any decals except for the Philco logo on the '36 models. The 37-116 did but  116B and116X didn't.
> Looking from the front, is the BC band extreme right?
Typically the bands are presented from top to bottom. Do you mean the bandswitch position?

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#3

The 1936 Philco 650 only had a PHILCO decal (DCL-PH8 from Radio Daze).

The band selections, from left to right looking at the front of the set, are: LW, AM (BC), "Police", SW.

--
Ron Ramirez
Ferdinand IN
#4

Thanks guys. You still have game.
#5

Gee Ron, you always have the answers in your back pocket. Could this be your first slip. Turns out (if the book is correct) that Philco put a long-wave weather band extreme counterclockwise on the 650. The standard broadcast is second from left, followed by two SW bands. Who da thunk it?


Attached Files Image(s)
   
#6

I was biting my tongue as I noticed that the 650 has LW reception. Was thinking it would a little out of place to have LW band after the MW band.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#7

So who's perfect? Icon_lolno It's been so long since I worked on a 650 that I forgot about the LW band. Icon_redface I edited post #3 above to reflect that fact.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
The speaker table error?
G  10-1/2"       65, 76, 87, 95 Push-Pull 45's 2766 0.7 550 3200 H   10-1/2"    77, 96 Push-Pull...morzh — 09:26 PM
A Marconi model 86
I have a Stromberg, one of the early ones, seems early 30s. This is what I call a back breaker. None of the early Philc...morzh — 08:28 PM
A Marconi model 86
A backbreaker.....PaulPaul Philco322 — 08:12 PM
A Marconi model 86
>>What a behemoth! A Juggernaut.morzh — 07:47 PM
Philco 70 antenna lead
I am not sure I understood about the coils and the mush. I looked an more than one coil in 20, 70, 90, 60, Zeniths and ...morzh — 07:46 PM
A Marconi model 86
:e_biggrin: What a behemoth!  I hope the final result is as much a quality sounding example!  Keep us posted on your pro...GarySP — 07:32 PM
A Marconi model 86
I should add that the double conversion may only be used on the shortwave bands, but I haven't looked at the schematic t...Arran — 07:27 PM
Philco 70 antenna lead
Yes, that wire will not pick up much interference as routed - the RF at that level won't be affected, and if you have st...radio1 — 07:26 PM
Philco model 60
I'm also a member of MARC. Did you attend the Vintage Electronics Expo in Waterford, MI last month? That's where I got...GarySP — 07:22 PM
A Marconi model 86
Dan Double conversion is using two IF converters instead of one. This improves the image response. morzh — 07:15 PM

[-]
Who's Online
There are currently 6078 online users. [Complete List]
» 1 Member(s) | 6077 Guest(s)
Avatar

>