Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

46-1226 Mystery Cap
#1

I'm working on a 46-1226 Am/Lw/Sw/Phono console. Has anyone else done this beastie? There is a rather large cap that I can not determine its value for replacement. I've consulted the Schematic in the Rider's on Nostalgia Air without much luck.

It's a very large yellow tubular cap with wax coating that's located about dead-center in the middle of the bottom of the chassis. The ends are attached to a large terminal strip and one end goes to one of the electrolytic caps and the other to one of terminals on the volume control pot.

I accidentally scratched off the value while trying to cut through the filthy wax. I thought it said something like 25 - but don't recall and there's nothing on the schematic that makes sense.

Can anyone help? I could take a photo of the cap in location if it would help.

Thanks,
James
#2

What C number is it on the riders underside picture?
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#3

Do you have the schematic for this radio? The service information will tell you what capacitor it is. Philco service literature for their 1946 models are very detailed.

If you don't have it, you need to get hold of Chuck and buy it from him - you won't be disappointed.

http://www.philcorepairbench.com/schematics.htm

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
The speaker table error?
G  10-1/2"       65, 76, 87, 95 Push-Pull 45's 2766 0.7 550 3200 H   10-1/2"    77, 96 Push-Pull...morzh — 09:26 PM
A Marconi model 86
I have a Stromberg, one of the early ones, seems early 30s. This is what I call a back breaker. None of the early Philc...morzh — 08:28 PM
A Marconi model 86
A backbreaker.....PaulPaul Philco322 — 08:12 PM
A Marconi model 86
>>What a behemoth! A Juggernaut.morzh — 07:47 PM
Philco 70 antenna lead
I am not sure I understood about the coils and the mush. I looked an more than one coil in 20, 70, 90, 60, Zeniths and ...morzh — 07:46 PM
A Marconi model 86
:e_biggrin: What a behemoth!  I hope the final result is as much a quality sounding example!  Keep us posted on your pro...GarySP — 07:32 PM
A Marconi model 86
I should add that the double conversion may only be used on the shortwave bands, but I haven't looked at the schematic t...Arran — 07:27 PM
Philco 70 antenna lead
Yes, that wire will not pick up much interference as routed - the RF at that level won't be affected, and if you have st...radio1 — 07:26 PM
Philco model 60
I'm also a member of MARC. Did you attend the Vintage Electronics Expo in Waterford, MI last month? That's where I got...GarySP — 07:22 PM
A Marconi model 86
Dan Double conversion is using two IF converters instead of one. This improves the image response. morzh — 07:15 PM

[-]
Who's Online
There are currently 6310 online users. [Complete List]
» 1 Member(s) | 6309 Guest(s)
Avatar

>