Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

[split] Zenith Hi-Fidelity Phonograph Console
#1

I also have the same record player, that I have been trying to rehab for a friend of mine as the needle on the record player had its LP needle tip busted off but the 78 needle was still in good shape (it uses the old EV Power-Point Needles, which for some reason seem to have a tendancy to fail the same way after a while which is to have the LP tip break off after not even 8 plays but the 78 tip survives intact just fine).

For some reason or another when I have tried to order a new needle for this record player, I can never seem to get the right needle ordered for it, I keep ordering a needle that's too big for the needle mount and I have the original needle and I've been using that to go by to get the replacement and when I try to order the replacement needle from Gary Stork over at Voice of Music Enthusiasts I order one that looks like it should be the correct one, but then when it actually comes in the mail and I try it out on the record player it ends up being the wrong one, and I've done that 5 times already.  
It doesn't help matters any that EV made 6 different power-point needles that all look the same but are sized slightly different and some are stereo and some are mono and over at Voice of Music Enthusiasts the only pictures he has of the EV Power-Point needles are drawings from factory literature which drawings aren't going to help out much in identifying what needle you need especially when all they go by are part numbers and the original needle in this record player didn't have a part number stamped or etched into it anywhere.)

Does anyone know which needle this record player uses?
#2

[Admin Note] split this into a separate thread since this is about a new project.

Other thread: https://philcoradio.com/phorum/showthread.php?tid=18907




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Heathkit Sweep Generator TS-4
Ron Instead of Quick reply, go to New Reply, then go to the title of the very first post, and change the title text the...morzh — 02:00 PM
6TPZ and 5TPO Radio Help
I am not a specialist in car radios. I suspect they might use vibrators to convert 12V to acceptable tube voltages, so ...morzh — 01:58 PM
6TPZ and 5TPO Radio Help
Welcome to the Phorum, R3Sons! I have very limited experience with car radios other than installing custom radios back ...GarySP — 01:08 PM
462ron
OK, I need to rename this thread to say..Eico 368 TV/FM Sweep Generator instead of the current title..Heathkit Sweep Gen...462ron — 12:49 PM
6TPZ and 5TPO Radio Help
Hello, I have a Philco (Ford) 6TPZ and a 5TPO radio.  I replaced the electrolytic capacitors in both.  I have the SAMS m...R3Sons — 12:29 PM
The list of my radio & TV collection!
Hello Peter, Thank you for posting that !! Sincerely Richardradiorich — 09:40 AM
Eico 232 VTVM Schematic
It's a microwave antenna. ?;-p?. I substituted 1N4002s off the 6.3 vac winding for the 1.5 volt battery. Uniprobe is the...RodB — 05:50 PM
Eico 232 VTVM Schematic
Try BAMA for a schematic. Looks like a replacement power source for the D battery has been installed. The tube may be...Chas — 04:51 PM
Eico 232 VTVM Schematic
Is that a battery holder?morzh — 04:43 PM
Eico 232 VTVM Schematic
A friend gave me this Eico 232 VTVM and I'm having trouble locating the schematic for it. This one seems to be a later v...RodB — 04:17 PM

[-]
Who's Online
There are currently no members online.

>