Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

RCA 45-EY-3
#1

OK Some problems with this Recapped all .. Electrolytic and all other caps.. Did not change any resistors. All were withing spec.. I did change all three tubes Same problem...

The cam in middle is all messed up.. But I think that should not cause the player to not work..

player spins and when needle is put on record i can hear it a little .. Turn volume up all the way and extremely low volume

If I pick up the needle and scratch it I can her a load hum.. So I assume the amp part is working..

and the cartridge also.. So why NO good sound??

Help

Skip
#2

If you are still trying to use the original sodium cartridge, you won't get much. They are always DOA and need to be replaced.

No matter where you go, there you are.
#3

Ok.. Even if I scratch the needle and get noise?

Skip
#4

Yep. Sometimes a cartridge will have a little life left in it and make sound that way, but still be weak. Finding a more modern cartridge that you can adapt in is a better choice. If nothing else, it is way lighter and friendlier on your records!

No matter where you go, there you are.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
The list of my radio & TV collection!
Hello Peter, Thank you for posting that !! Sincerely Richardradiorich — 09:40 AM
Eico 232 VTVM Schematic
It's a microwave antenna. ?;-p?. I substituted 1N4002s off the 6.3 vac winding for the 1.5 volt battery. Uniprobe is the...RodB — 05:50 PM
Eico 232 VTVM Schematic
Try BAMA for a schematic. Looks like a replacement power source for the D battery has been installed. The tube may be...Chas — 04:51 PM
Eico 232 VTVM Schematic
Is that a battery holder?morzh — 04:43 PM
Eico 232 VTVM Schematic
A friend gave me this Eico 232 VTVM and I'm having trouble locating the schematic for it. This one seems to be a later v...RodB — 04:17 PM
Var resistor id
Considering what it is in series with, I doubt there should be any power requirements. Of course, we should know wher...morzh — 03:23 PM
Var resistor id
Trim pot, about 1/2 watt part of focus divider. As stated 2k ohms. This appears to be a rusty chassis, resolder all ...Chas — 03:19 PM
Var resistor id
Its a Sylvania 400 oscilloscope. here is a clip of r-100. Would be nice to know the current required. Not listed in part...Martinj — 02:10 PM
The list of my radio & TV collection!
Thanks Richard. I hope you enjoy it. Here I have created an English section on the history of radio with videos in Engl...RadioSvit — 10:23 AM
The list of my radio & TV collection!
Hello RadioSvit, first all happy new year ! I will watch your new videos this week. Sincerely Richardradiorich — 09:19 AM

[-]
Who's Online
There are currently 3933 online users. [Complete List]
» 2 Member(s) | 3931 Guest(s)
AvatarAvatar

>