Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

40-165 vs 41-260
#1

Today I was reading the classifieds in our local paper to find a Philco console radio for sale for $100. Curious, I called on the radio and inquired as to what model it was. The seller checked and said it is a 41-260 that is in good shape and working. Guess his wife got it and is now not in love with it anymore. Anyways, I wasn't sure I wanted it because I have a nice 40-165 that works well and really both look to be the same radio except that the cabinet on the 41-260 might be a bit different and it appears to be a 7 tube chassis. Was one radio better than the other or is the performance the same?

No matter where you go, there you are.
#2

Hi Jayce
The sets are pretty similar but the '165 has a rf amp before the mixer, but the '260 has no rf amp but two IF amps
So the '165 should pickup more stations (has more front end gain) but can't separate them apart where the '260 should be able to separate them better (better selectivity because of more IF gain).
Audio looks to be the same. I'd say it's a toss up.
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#3

Ok. Thanks for helping me sort that out. My little 40-165 is actually great at receiving stations and is sometimes the only radio in my collection that can sort our local station out of the background noise at night when they turn the power down. I did take down the info on the 41-260 and figure I can pass the info on if anything else. It's hard to sell old radios around here, so I wish the guy luck.

No matter where you go, there you are.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM
RCA 15X
I'd try replacing the bulb first and if that doesn't do it, then change the 35Z5 and see if the problem goes away.NostalgiaRadioTime — 12:28 AM
B&K 1077B no video
Hello Tim, I have that exact unit in my shop too plus a Sencore unit there are times I like one or other !!. Sincerely...radiorich — 11:07 PM
RCA 15X
Everthing goes at once, maybe it's the cold weather, I have had 2 dial strings break and no my little RCA is having dial...Paul Philco322 — 10:26 PM
Philco 91 Schematic
Hi Dan, I can't explain this specific resistor but I have seen the use of a switch to apply B+ voltage to screen gri...RodB — 09:36 PM
6TPZ and 5TPO Radio Help
I suspect it's been repaired before. And I suspect whoever repaired it, wanted to re-use old transistors' pin stubs in o...morzh — 09:24 PM

[-]
Who's Online
There are currently 9701 online users. [Complete List]
» 3 Member(s) | 9698 Guest(s)
AvatarAvatarAvatar

>