Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

PREDICTA...
#1

After a few years and a few headaches, mine is finally restored. I have reason to think mine was used by either Holiday Inn or Howard Johnson's. I still need to play with 6DR7's, since the vertical isn't perfect, but it works.

Note from site admin: Sorry, but the photo which was attached to this post is no longer available.

Visit the world's worst TV restoration website.

http://evilfurnaceman.tripod.com
#2

that's a nice set for sure!

-Mars
#3

I confirmed slight leakage in the vertical output tube. Now, the linearity is as close as I can get it. Here's a better shot.

Note from site admin: Sorry, but the photo which was attached to this post is no longer available.

Visit the world's worst TV restoration website.

http://evilfurnaceman.tripod.com
#4

Nice looking set! Good job. I've got a Siesta that's on my todo list one of these years. I hear they are kind of a pain to work on.
http://www.flickr.com/photos/42774321@N0...otostream/
It should say I haven't had a chance to check it over...
Tnx for posting. It gives some of slow pokes some encouragement.
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#5

I just seen a predicta sell on ebay for $1800.00 wasnt the same model but close




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Heathkit Sweep Generator TS-4
Ron Instead of Quick reply, go to New Reply, then go to the title of the very first post, and change the title text the...morzh — 02:00 PM
6TPZ and 5TPO Radio Help
I am not a specialist in car radios. I suspect they might use vibrators to convert 12V to acceptable tube voltages, so ...morzh — 01:58 PM
6TPZ and 5TPO Radio Help
Welcome to the Phorum, R3Sons! I have very limited experience with car radios other than installing custom radios back ...GarySP — 01:08 PM
462ron
OK, I need to rename this thread to say..Eico 368 TV/FM Sweep Generator instead of the current title..Heathkit Sweep Gen...462ron — 12:49 PM
6TPZ and 5TPO Radio Help
Hello, I have a Philco (Ford) 6TPZ and a 5TPO radio.  I replaced the electrolytic capacitors in both.  I have the SAMS m...R3Sons — 12:29 PM
The list of my radio & TV collection!
Hello Peter, Thank you for posting that !! Sincerely Richardradiorich — 09:40 AM
Eico 232 VTVM Schematic
It's a microwave antenna. ?;-p?. I substituted 1N4002s off the 6.3 vac winding for the 1.5 volt battery. Uniprobe is the...RodB — 05:50 PM
Eico 232 VTVM Schematic
Try BAMA for a schematic. Looks like a replacement power source for the D battery has been installed. The tube may be...Chas — 04:51 PM
Eico 232 VTVM Schematic
Is that a battery holder?morzh — 04:43 PM
Eico 232 VTVM Schematic
A friend gave me this Eico 232 VTVM and I'm having trouble locating the schematic for it. This one seems to be a later v...RodB — 04:17 PM

[-]
Who's Online
There are currently 6695 online users. [Complete List]
» 2 Member(s) | 6693 Guest(s)
AvatarAvatar

>