Posts: 371
Threads: 103
Joined: Jul 2011
City: Calgary, AB, CA
I am working on a Philco model 650 and I find two caps that are not listed .
I would like to know the values of them.. They are Philco caps and the number of both of them is 30-4024S. the parts list does not show them. I think someone had replaced the original ones with this number.
They go from the speaker plug to ground.
Thanks Dan
Posts: 5,128
Threads: 271
Joined: Nov 2012
City: Wilsonville
State, Province, Country: OR
Posts: 371
Threads: 103
Joined: Jul 2011
City: Calgary, AB, CA
Thanks Bob, I thought that was the value by the schematics. I find that the Philco schematics are a lot harder to read than some of the others. I know it just takes time to learn, but that is what this forum is all about
Thanks Dan
Posts: 371
Threads: 103
Joined: Jul 2011
City: Calgary, AB, CA
I checked my supply of caps and I have a .022@1600 volts and a .05@1000 volts.. I think that the .05 is too large, but could I use the .022 in place of the .006? Dan
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand
State, Province, Country: Indiana
They are on the USA 650 schematic - parts (86) and (87). Original part no. 30-4125, .006 uF. 30-4024 may be replacements for 30-4125?
http://www.nostalgiaair.org/PagesByModel...013824.pdf
Do not use .05 or .022 uF. Anything larger than .0068 uF will adversely affect the tone (cut the highs). Use .0047 or .0068 uF, 1000 volts.
--
Ron Ramirez
Ferdinand IN
Posts: 5,128
Threads: 271
Joined: Nov 2012
City: Wilsonville
State, Province, Country: OR
For Philcos between 1928 and 1947 you can get very clear and complete documentation from
Chuck Schwark's Philco Repair Bench site for just a few bucks.
Posts: 371
Threads: 103
Joined: Jul 2011
City: Calgary, AB, CA
Thank you for the information.. I have ordered the documentation from Chuck.
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
