Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Pros and Cons of Refinishing the 511 Series cabinets
#19

Jim Berg Wrote:I am not sure what prices these set bring, but to have an artist duplicate the work on the set would not be cheap. I would be more inclined to clean it up and maybe have some touch up done. I would like to find one of these in good shape someday, but have not seen any over the years. A good artist should be able to touch up the cabinet and it should blend in very well. My mom was an artist and did some restorations on old paintings. It required mixing different colors to get the proper shade of the aged paint.

Actually it is probably easier to paint a replica then it is to touch up an original, as you mentioned you need to custom mix the paints just right so the repairs don't stand out against the old paint. If you were to take a 511, strip it, and repaint it to replicate a 512, 513, etc, then you would be starting with a blank "canvas" so to speak. There would be no need to exactly match colours or brush strokes since no two of the originals were the same to begin with. To me the flowers on most of those models remind me of the ones that tole painters make, several layers of replicated brush strokes to form leaves and flower pedals, making an acceptable facsimile should not be too difficult to someone artistically inclined.
With the 515 model, "The Impressionistic", was that a design that was offered from the factory? A prototype maybe? Or some type of one off that was special ordered?
Best Regards
Arran


Messages In This Thread
Re: Pros and Cons of Refinishing the 511 Series cabinets - by Arran - 05-07-2009, 09:51 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Heathkit Sweep Generator TS-4
Ron Instead of Quick reply, go to New Reply, then go to the title of the very first post, and change the title text t...morzh — 02:00 PM
6TPZ and 5TPO Radio Help
I am not a specialist in car radios. I suspect they might use vibrators to convert 12V to acceptable tube voltages, so ...morzh — 01:58 PM
6TPZ and 5TPO Radio Help
Welcome to the Phorum, R3Sons! I have very limited experience with car radios other than installing custom radios back ...GarySP — 01:08 PM
462ron
OK, I need to rename this thread to say..Eico 368 TV/FM Sweep Generator instead of the current title..Heathkit Sweep Gen...462ron — 12:49 PM
6TPZ and 5TPO Radio Help
Hello, I have a Philco (Ford) 6TPZ and a 5TPO radio.  I replaced the electrolytic capacitors in both.  I have the SAMS m...R3Sons — 12:29 PM
The list of my radio & TV collection!
Hello Peter, Thank you for posting that !! Sincerely Richardradiorich — 09:40 AM
Eico 232 VTVM Schematic
It's a microwave antenna. ?;-p?. I substituted 1N4002s off the 6.3 vac winding for the 1.5 volt battery. Uniprobe is the...RodB — 05:50 PM
Eico 232 VTVM Schematic
Try BAMA for a schematic. Looks like a replacement power source for the D battery has been installed. The tube may be...Chas — 04:51 PM
Eico 232 VTVM Schematic
Is that a battery holder?morzh — 04:43 PM
Eico 232 VTVM Schematic
A friend gave me this Eico 232 VTVM and I'm having trouble locating the schematic for it. This one seems to be a later v...RodB — 04:17 PM

[-]
Who's Online
There are currently 6558 online users. [Complete List]
» 2 Member(s) | 6556 Guest(s)
AvatarAvatar

>