06-09-2016, 10:06 PM
Will do
Far as the alignment goes following Ron's method I get 9Vdc AGC voltage at 1500KHz and with the dial set around 593KHz I get 5.5Vdc AGC voltage and I can get it no better than that.
I still believe that the high side LO trimmer adjustment nut is farther out than where it was when I had near perfect dial tracking.
Oddly enough I was able to get a peak at 1500KHz today without adjusting the low frequency LO trimmer.
Far as the alignment goes following Ron's method I get 9Vdc AGC voltage at 1500KHz and with the dial set around 593KHz I get 5.5Vdc AGC voltage and I can get it no better than that.
I still believe that the high side LO trimmer adjustment nut is farther out than where it was when I had near perfect dial tracking.
Oddly enough I was able to get a peak at 1500KHz today without adjusting the low frequency LO trimmer.