[Ron Ramirez]

Time to continue with this project...

[Image: http://www.philcoradio.com/images/phorum/37640_067.jpg]

As you can see, the electrolytic can is back in place and I've reinstalled the RF section.

[Image: http://www.philcoradio.com/images/phorum/37640_068.jpg]

This shows the single wire is now soldered to the positive terminal of the electrolytic .

[Image: http://www.philcoradio.com/images/phorum/37640_069.jpg]

Now, the antenna section is back in place.

[Image: http://www.philcoradio.com/images/phorum/37640_070.jpg]

Another view of the underside of the rebuilt RF unit.

[Image: http://www.philcoradio.com/images/phorum/37640_071.jpg]

And a view of the topside of the RF unit.

Since I took this picture, I have also replaced the two grid wires which are soldered to the tuning condenser. I have also soldered the wires which come through from inside the RF unit back to the tuning condenser.

The RF unit is almost ready for reinstallation in the main chassis...but not quite...