Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Radiola 60 ??
#15

Take your 201As and test them at 5V on the filament - no, not what the switch says - with a volt meter on the filaments - like Arran said. While the tube tester may be designed to accommodate the voltage drop, this is still meaningful for normal operation from a 6V battery.

If they don't put out ~ 450 mho, you can run them at 5.5V - yeah with a volt meter - for a few hours. Then run them at 5V for a few hours. Then test again. You can learn some by pushing the test button at 5.5V. That is - that if the emissions go up it is possible that this process might revive the tube. If the emissions do not go up at 5.5V you are probably wasting time. This IS NOT the conventional rejuvenation process for thorium impregnated filaments but for thorium coated filaments.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/


Messages In This Thread
Radiola 60 ?? - by vecher - 01-05-2017, 01:01 AM
RE: Radiola 60 ?? - by Arran - 01-05-2017, 04:54 AM
RE: Radiola 60 ?? - by Fred Taylor - 01-05-2017, 08:54 AM
RE: Radiola 60 ?? - by Mondial - 01-05-2017, 09:07 AM
RE: Radiola 60 ?? - by Jayce - 01-05-2017, 12:48 PM
RE: Radiola 60 ?? - by klondike98 - 01-05-2017, 01:32 PM
RE: Radiola 60 ?? - by vecher - 01-05-2017, 01:58 PM
RE: Radiola 60 ?? - by vecher - 01-05-2017, 03:50 PM
RE: Radiola 60 ?? - by Arran - 01-09-2017, 05:11 AM
RE: Radiola 60 ?? - by Jayce - 01-06-2017, 12:13 AM
RE: Radiola 60 ?? - by Fred Taylor - 01-06-2017, 08:44 AM
RE: Radiola 60 ?? - by Jayce - 01-09-2017, 07:46 PM
RE: Radiola 60 ?? - by Arran - 01-10-2017, 04:49 AM
RE: Radiola 60 ?? - by Jayce - 01-15-2017, 01:18 PM
RE: Radiola 60 ?? - by Phlogiston - 01-15-2017, 03:13 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
An attempt to remove the Field Coil from a G speaker
Gary I in fact did, on a 38-14, I think, where I had a speaker with the dead coil. Well...it kinda worked. Kinda, be...morzh — 10:38 PM
An attempt to remove the Field Coil from a G speaker
Mike, what ever happened to that plan you had to try using a rare earth magnet to magnetize the pole? This looks like a...GarySP — 10:25 PM
RCA T62 is playing.....
Beautiful set.morzh — 09:07 PM
An attempt to remove the Field Coil from a G speaker
Well....here it is. The green stuff. Unfortunately, probably penetrates deep. I opened the top layer and saw that: ...morzh — 08:58 PM
Philco 91 Restore Code ??
:clap: :clap: :clap: :clap: Really nice workmanship!!! Top of the chassis looks great. Sorry about the long winded e...MrFixr55 — 08:09 PM
Philco 40-120C Restoration
Thank you for your reply. I will check voltages on the other tubes, look at resistor 23 and cap 25, etc. If all else fai...bluecap — 07:58 PM
RCA T62 is playing.....
Nice looking set great save. DavidDavid — 07:48 PM
Philco 89 indicator light.
Hello Jim, I have done several 89s. The trick is to move the drum in or out on it's shaft. You will need to loosen a set...dconant — 07:36 PM
An attempt to remove the Field Coil from a G speaker
MrFixr Yes, it is my plan to go with 45rpm spider if I go that far. No, the pole was not left-handed as I unscrewed ...morzh — 07:14 PM
Philco 40-120C Restoration
Change the tube. Check the tube's bias network. Are any other tubes experience the drop or just this?` Is resistor 23 OK...morzh — 07:09 PM

[-]
Who's Online
There are currently 6787 online users. [Complete List]
» 1 Member(s) | 6786 Guest(s)
Avatar

>