1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Please ID this Silvertone
Radioroslyn
Phorum Expert
*****
Posts: 7,294
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#4

05-23-2017, 07:39 AM
Hope your resistance line cord is good! If not you'll need to scare up a 7.4mf non polarized cap to drop the heater voltage.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Please ID this Silvertone - by vecher - 05-22-2017, 11:42 PM
RE: Please ID this Silvertone - by OldRestorer - 05-23-2017, 12:11 AM
RE: Please ID this Silvertone - by vecher - 05-23-2017, 01:11 AM
RE: Please ID this Silvertone - by Radioroslyn - 05-23-2017, 07:39 AM
RE: Please ID this Silvertone - by Eliot Ness - 05-23-2017, 08:37 AM
RE: Please ID this Silvertone - by Radioroslyn - 05-23-2017, 09:13 AM
RE: Please ID this Silvertone - by sam - 05-23-2017, 11:19 AM
RE: Please ID this Silvertone - by OldRestorer - 05-23-2017, 04:09 PM
RE: Please ID this Silvertone - by Radioroslyn - 05-23-2017, 05:00 PM
RE: Please ID this Silvertone - by vecher - 05-23-2017, 08:38 PM
RE: Please ID this Silvertone - by vecher - 07-04-2017, 12:09 AM
RE: Please ID this Silvertone - by vecher - 07-04-2017, 08:32 PM
RE: Please ID this Silvertone - by Radioroslyn - 07-05-2017, 06:18 PM
RE: Please ID this Silvertone - by vecher - 07-05-2017, 11:28 PM
RE: Please ID this Silvertone - by Radioroslyn - 07-06-2017, 12:30 AM
RE: Please ID this Silvertone - by vecher - 07-07-2017, 12:08 AM
RE: Please ID this Silvertone - by vecher - 09-22-2017, 11:17 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
An attempt to remove the Field Coil from a G speaker
Gary I in fact did, on a 38-14, I think, where I had a speaker with the dead coil. Well...it kinda worked. Kinda, be...morzh — 10:38 PM
An attempt to remove the Field Coil from a G speaker
Mike, what ever happened to that plan you had to try using a rare earth magnet to magnetize the pole? This looks like a...GarySP — 10:25 PM
RCA T62 is playing.....
Beautiful set.morzh — 09:07 PM
An attempt to remove the Field Coil from a G speaker
Well....here it is. The green stuff. Unfortunately, probably penetrates deep. I opened the top layer and saw that: ...morzh — 08:58 PM
Philco 91 Restore Code ??
:clap: :clap: :clap: :clap: Really nice workmanship!!! Top of the chassis looks great. Sorry about the long winded e...MrFixr55 — 08:09 PM
Philco 40-120C Restoration
Thank you for your reply. I will check voltages on the other tubes, look at resistor 23 and cap 25, etc. If all else fai...bluecap — 07:58 PM
RCA T62 is playing.....
Nice looking set great save. DavidDavid — 07:48 PM
Philco 89 indicator light.
Hello Jim, I have done several 89s. The trick is to move the drum in or out on it's shaft. You will need to loosen a set...dconant — 07:36 PM
An attempt to remove the Field Coil from a G speaker
MrFixr Yes, it is my plan to go with 45rpm spider if I go that far. No, the pole was not left-handed as I unscrewed ...morzh — 07:14 PM
Philco 40-120C Restoration
Change the tube. Check the tube's bias network. Are any other tubes experience the drop or just this?` Is resistor 23 OK...morzh — 07:09 PM

[-]
Who's Online
There are currently 7093 online users. [Complete List]
» 1 Member(s) | 7092 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)