06-20-2017, 05:10 PM
I think most would just solder in 4 separates. Some would take the can apart (grinding off the bottom flange removing the innards and resealing the bottom or cutting the side open abt an inch above the bottom clean it out put new caps in and close it up by wrapping a layer of al tape) and restuffing. Or : https://hayseedhamfest.com/pages/custom-can-capacitor
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
