Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 41-608 connector question.
#16

Hi Harlan,

The 42-1015 I am currently working on uses a 32-8196. Nostalgia Air has the schematic for it: http://www.nostalgiaair.org/PagesByModel...013499.pdf The transformer is part 97. I'll try to remember to check the resistances on my transformer tonight.

Sean
WØKPX


Messages In This Thread
Philco 41-608 connector question. - by Harlan - 01-06-2010, 10:27 PM
Re: Philco 41-608 connector question. - by Sean - 01-06-2010, 10:43 PM
Re: Philco 41-608 connector question. - by Harlan - 01-06-2010, 11:44 PM
Re: Philco 41-608 connector question. - by Sean - 01-07-2010, 10:14 AM
Re: Philco 41-608 connector question. - by Harlan - 01-07-2010, 11:14 AM
Re: Philco 41-608 connector question. - by Sean - 01-07-2010, 01:00 PM
Re: Philco 41-608 connector question. - by Harlan - 01-07-2010, 07:24 PM
Re: Philco 41-608 connector question. - by Sean - 01-08-2010, 12:19 PM
Re: Philco 41-608 connector question. - by Sean - 01-09-2010, 12:41 AM
Re: Philco 41-608 connector question. - by Harlan - 01-09-2010, 01:03 AM
Re: Philco 41-608 connector question. - by Harlan - 01-10-2010, 07:25 PM
Re: Philco 41-608 connector question. - by Sean - 01-11-2010, 11:07 PM
Re: Philco 41-608 connector question. - by Harlan - 03-29-2010, 10:31 PM
Re: Philco 41-608 connector question. - by Sean - 03-30-2010, 09:19 AM
Re: Philco 41-608 connector question. - by Harlan - 03-30-2010, 10:14 AM
Re: Philco 41-608 connector question. - by Harlan - 03-30-2010, 09:38 PM
Re: Philco 41-608 connector question. - by Sean - 03-31-2010, 08:36 AM
Re: Philco 41-608 connector question. - by Harlan - 03-31-2010, 03:34 PM
Re: Philco 41-608 connector question. - by Sean - 04-01-2010, 09:37 AM
Re: Philco 41-608 connector question. - by Harlan - 04-01-2010, 10:01 AM
Re: Philco 41-608 connector question. - by Guest - 06-12-2010, 01:32 PM
Re: Philco 41-608 connector question. - by Harlan - 10-15-2010, 10:02 PM



Users browsing this thread: 7 Guest(s)
[-]
Recent Posts
An attempt to remove the Field Coil from a G speaker
Gary I in fact did, on a 38-14, I think, where I had a speaker with the dead coil. Well...it kinda worked. Kinda, be...morzh — 10:38 PM
An attempt to remove the Field Coil from a G speaker
Mike, what ever happened to that plan you had to try using a rare earth magnet to magnetize the pole? This looks like a...GarySP — 10:25 PM
RCA T62 is playing.....
Beautiful set.morzh — 09:07 PM
An attempt to remove the Field Coil from a G speaker
Well....here it is. The green stuff. Unfortunately, probably penetrates deep. I opened the top layer and saw that: ...morzh — 08:58 PM
Philco 91 Restore Code ??
:clap: :clap: :clap: :clap: Really nice workmanship!!! Top of the chassis looks great. Sorry about the long winded e...MrFixr55 — 08:09 PM
Philco 40-120C Restoration
Thank you for your reply. I will check voltages on the other tubes, look at resistor 23 and cap 25, etc. If all else fai...bluecap — 07:58 PM
RCA T62 is playing.....
Nice looking set great save. DavidDavid — 07:48 PM
Philco 89 indicator light.
Hello Jim, I have done several 89s. The trick is to move the drum in or out on it's shaft. You will need to loosen a set...dconant — 07:36 PM
An attempt to remove the Field Coil from a G speaker
MrFixr Yes, it is my plan to go with 45rpm spider if I go that far. No, the pole was not left-handed as I unscrewed ...morzh — 07:14 PM
Philco 40-120C Restoration
Change the tube. Check the tube's bias network. Are any other tubes experience the drop or just this?` Is resistor 23 OK...morzh — 07:09 PM

[-]
Who's Online
There are currently no members online.

>