Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

New member and new (to me) 37-9
#6

Hey Bob that must be the same set no bandswitch knob!

Hi Spook and welcome,
Here a little info on the automatic tuning.    https://web.archive.org/web/201702040249.../index.htm
It may be just something simple like the front of the chassis is sitting a b it low causing the part that turns to rub on the stationary dial escutcheon.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
New member and new (to me) 37-9 - by Spook50 - 01-09-2018, 05:36 PM
RE: New member and new (to me) 37-9 - by morzh - 01-09-2018, 05:49 PM
RE: New member and new (to me) 37-9 - by Spook50 - 01-09-2018, 06:03 PM
RE: New member and new (to me) 37-9 - by Radioroslyn - 01-09-2018, 11:11 PM
RE: New member and new (to me) 37-9 - by Spook50 - 01-10-2018, 12:02 AM
RE: New member and new (to me) 37-9 - by morzh - 01-10-2018, 09:02 AM
RE: New member and new (to me) 37-9 - by Arran - 01-11-2018, 01:32 AM
RE: New member and new (to me) 37-9 - by morzh - 01-11-2018, 12:16 PM
RE: New member and new (to me) 37-9 - by Arran - 01-12-2018, 12:12 AM
RE: New member and new (to me) 37-9 - by Spook50 - 01-21-2018, 09:59 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
6TPZ and 5TPO Radio Help
Quick progress report: X7 is broken. Only one leg soldered, the other missing and the diode is cracked. I've replaced...R3Sons — 05:05 PM
6TPZ and 5TPO Radio Help
Oh...and you have electrolytic caps there. All need to go and be replaced.morzh — 04:36 PM
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM
RCA 15X
I'd try replacing the bulb first and if that doesn't do it, then change the 35Z5 and see if the problem goes away.NostalgiaRadioTime — 12:28 AM
B&K 1077B no video
Hello Tim, I have that exact unit in my shop too plus a Sencore unit there are times I like one or other !!. Sincerely...radiorich — 11:07 PM

[-]
Who's Online
There are currently 7318 online users. [Complete List]
» 2 Member(s) | 7316 Guest(s)
AvatarAvatar

>