Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Speaking of Knobs
#5

Getting back to the Hippo knobs, I think that if one of the hippo models had gold painted rings it's possible that someone may have used replacement knobs off of a 46-1201 or 48-1201 "Bing Crosby" as they are of the same design. I'm not sure about the hippo sets but the 'Bing Crosby's" originally came with gold rings painted around the perimeter of the knobs, though they are worn off on my Canadian built example.
Regards
Arran


Messages In This Thread
Speaking of Knobs - by Prange - 01-21-2018, 06:07 PM
RE: Speaking of Knobs - by Arran - 01-22-2018, 12:51 AM
RE: Speaking of Knobs - by OldRestorer - 01-22-2018, 09:33 AM
RE: Speaking of Knobs - by Kenneth F. Besso Jr. - 01-22-2018, 08:45 PM
RE: Speaking of Knobs - by Arran - 01-25-2018, 10:59 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
462ron
Hi Levi, here’s just a thought. Most radios run the oscillator higher than the dial setting. Say you set your radio to 1...462ron — 10:10 AM
1930s Stewart-Warner Tombstone Radio need help identifying model number
Another Update: I found a couple of damaged coils inside this radio that might have something to do with why this radio ...captainclock1988 — 10:51 PM
6TPZ and 5TPO Radio Help
If you are still on 5TPO, you lost me there. What X7? What Points 1 and 2?morzh — 08:37 PM
6TPZ and 5TPO Radio Help
Quick progress report: X7 is broken. Only one leg soldered, the other missing and the diode is cracked. I've replaced...R3Sons — 05:05 PM
6TPZ and 5TPO Radio Help
Oh...and you have electrolytic caps there. All need to go and be replaced.morzh — 04:36 PM
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM

[-]
Who's Online
There are currently 6146 online users. [Complete List]
» 3 Member(s) | 6143 Guest(s)
AvatarAvatarAvatar

>