Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco model 84
#4

Your 84 should play rather well for the kind of radio it is. It will have some audio distortion due to its cheap design, but it should have little if any hum.

Please double-check to make sure the negatives of the filter capacitors are connected to the center tap of the power transformer's high voltage secondary, as Terry has suggested. The 77 2nd detector tube or the 42 output tube could have a heater to cathode short, or leakage? This will cause problems.

Check all of your resistors. I've find that of the 80, 81 and 84 sets I have serviced over the years, that the resistors have almost always changed in value from their original ratings. If they deviate more than 20% from published specifications, they need to be changed.

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
philco model 84 - by vinzer - 05-02-2010, 04:37 PM
Re: philco model 84 - by 7estatdef - 05-03-2010, 08:56 AM
Re: philco model 84 - by vinzer - 05-03-2010, 06:22 PM
Re: philco model 84 - by Ron Ramirez - 05-03-2010, 08:50 PM
Re: philco model 84 - by vinzer - 05-03-2010, 09:38 PM
Re: philco model 84 - by denver - 05-03-2010, 10:56 PM
Re: philco model 84 - by vinzer - 05-08-2010, 05:14 PM
Re: philco model 84 - by rghines1 - 05-09-2010, 06:08 PM
Re: philco model 84 - by vinzer - 05-09-2010, 09:10 PM
Re: philco model 84 - by Ed Locker - 05-10-2010, 09:01 AM
Re: philco model 84 - by gary rabbitt - 05-11-2010, 11:53 PM
Re: philco model 84 - by vinzer - 05-12-2010, 11:31 AM
Re: philco model 84 - by Chuck Schwark - 05-12-2010, 01:53 PM
Re: philco model 84 - by vinzer - 05-12-2010, 02:28 PM
Re: philco model 84 - by Chuck Schwark - 05-12-2010, 03:07 PM
Re: philco model 84 - by vinzer - 05-12-2010, 04:34 PM
Re: philco model 84 - by vinzer - 05-28-2010, 05:47 PM



Users browsing this thread: 7 Guest(s)
[-]
Recent Posts
An attempt to remove the Field Coil from a G speaker
Gary I in fact did, on a 38-14, I think, where I had a speaker with the dead coil. Well...it kinda worked. Kinda, be...morzh — 10:38 PM
An attempt to remove the Field Coil from a G speaker
Mike, what ever happened to that plan you had to try using a rare earth magnet to magnetize the pole? This looks like a...GarySP — 10:25 PM
RCA T62 is playing.....
Beautiful set.morzh — 09:07 PM
An attempt to remove the Field Coil from a G speaker
Well....here it is. The green stuff. Unfortunately, probably penetrates deep. I opened the top layer and saw that: ...morzh — 08:58 PM
Philco 91 Restore Code ??
:clap: :clap: :clap: :clap: Really nice workmanship!!! Top of the chassis looks great. Sorry about the long winded e...MrFixr55 — 08:09 PM
Philco 40-120C Restoration
Thank you for your reply. I will check voltages on the other tubes, look at resistor 23 and cap 25, etc. If all else fai...bluecap — 07:58 PM
RCA T62 is playing.....
Nice looking set great save. DavidDavid — 07:48 PM
Philco 89 indicator light.
Hello Jim, I have done several 89s. The trick is to move the drum in or out on it's shaft. You will need to loosen a set...dconant — 07:36 PM
An attempt to remove the Field Coil from a G speaker
MrFixr Yes, it is my plan to go with 45rpm spider if I go that far. No, the pole was not left-handed as I unscrewed ...morzh — 07:14 PM
Philco 40-120C Restoration
Change the tube. Check the tube's bias network. Are any other tubes experience the drop or just this?` Is resistor 23 OK...morzh — 07:09 PM

[-]
Who's Online
There are currently no members online.

>