Philco 70 volume issue

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 70 volume issue

Radioroslyn
Phorum Expert

Posts: 7,294
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

#10

02-10-2018, 07:08 PM

>No change....same issue.
Ok next thing to do is with the set off and the volume full up measure the resistance from the ant post to the chassis. Should see a fairly low resistance like less than 50ohms. If not the primary on the ant coil is bad and will need to be rewound.

GL

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

Find

« Next Oldest | Next Newest »

Thread Closed

Messages In This Thread

Philco 70 volume issue - by Radiowilbur - 02-10-2018, 11:21 AM

RE: Philco 70 volume issue - by bzadel - 02-10-2018, 01:32 PM

RE: Philco 70 volume issue - by Radiowilbur - 02-10-2018, 01:48 PM

RE: Philco 70 volume issue - by Radioroslyn - 02-10-2018, 01:49 PM

RE: Philco 70 volume issue - by Radiowilbur - 02-10-2018, 01:50 PM

RE: Philco 70 volume issue - by morzh - 02-10-2018, 02:17 PM

RE: Philco 70 volume issue - by Radiowilbur - 02-10-2018, 03:15 PM

RE: Philco 70 volume issue - by Radiowilbur - 02-10-2018, 04:52 PM

RE: Philco 70 volume issue - by morzh - 02-10-2018, 05:23 PM

RE: Philco 70 volume issue - by Radioroslyn - 02-10-2018, 07:08 PM

RE: Philco 70 volume issue - by Ron Ramirez - 02-10-2018, 08:07 PM

RE: Philco 70 volume issue - by Radiowilbur - 02-10-2018, 08:51 PM

RE: Philco 70 volume issue - by Radioroslyn - 02-10-2018, 08:53 PM

RE: Philco 70 volume issue - by Ron Ramirez - 02-10-2018, 10:48 PM

RE: Philco 70 volume issue - by morzh - 02-10-2018, 10:57 PM

RE: Philco 70 volume issue - by Ron Ramirez - 02-11-2018, 12:22 AM

RE: Philco 70 volume issue - by morzh - 02-11-2018, 12:27 AM

RE: Philco 70 volume issue - by Radiowilbur - 02-11-2018, 01:21 PM

RE: Philco 70 volume issue - by Radioroslyn - 02-11-2018, 04:30 PM

RE: Philco 70 volume issue - by Radiowilbur - 02-11-2018, 07:25 PM

RE: Philco 70 volume issue - by Radiowilbur - 02-11-2018, 08:23 PM

RE: Philco 70 volume issue - by Radioroslyn - 02-11-2018, 10:38 PM

View a Printable Version

Users browsing this thread: 6 Guest(s)

Recent Posts
The speaker table error?
G 10-1/2" 65, 76, 87, 95 Push-Pull 45's 2766 0.7 550 3200 H 10-1/2" 77, 96 Push-Pull...morzh — 09:26 PM
A Marconi model 86
I have a Stromberg, one of the early ones, seems early 30s. This is what I call a back breaker. None of the early Philc...morzh — 08:28 PM
A Marconi model 86
A backbreaker.....PaulPaul Philco322 — 08:12 PM
A Marconi model 86
>>What a behemoth! A Juggernaut.morzh — 07:47 PM
Philco 70 antenna lead
I am not sure I understood about the coils and the mush. I looked an more than one coil in 20, 70, 90, 60, Zeniths and ...morzh — 07:46 PM
A Marconi model 86
:e_biggrin: What a behemoth! I hope the final result is as much a quality sounding example! Keep us posted on your pro...GarySP — 07:32 PM
A Marconi model 86
I should add that the double conversion may only be used on the shortwave bands, but I haven't looked at the schematic t...Arran — 07:27 PM
Philco 70 antenna lead
Yes, that wire will not pick up much interference as routed - the RF at that level won't be affected, and if you have st...radio1 — 07:26 PM
Philco model 60
I'm also a member of MARC. Did you attend the Vintage Electronics Expo in Waterford, MI last month? That's where I got...GarySP — 07:22 PM
A Marconi model 86
Dan Double conversion is using two IF converters instead of one. This improves the image response. morzh — 07:15 PM

Who's Online

There are currently 5998 online users. [Complete List]
» 1 Member(s) | 5997 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me