1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
91D restoration
Guest
Unregistered
 
#14

07-12-2010, 02:14 PM
Ron:

You were exactly right (you probably get that a lot).

Also - the front door pulls also have very small brads holding then to the front of the doors as well as the obvious screws through each to the back of the doors.

Wood cleaning starting today with the Howard's Restore-a-finish (walnut).

Any thoughts on how to clean the now removed the brass piece surrounding the set's dial and shadow meter and door pulls?
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
91D restoration - by Guest - 07-02-2010, 04:37 PM
Re: 91D restoration - by Chuck Schwark - 07-03-2010, 01:27 PM
Re: 91D restoration - by Ron Ramirez - 07-04-2010, 08:38 AM
Re: 91D restoration - by Guest - 07-04-2010, 10:50 AM
Re: 91D restoration - by Ron Ramirez - 07-04-2010, 12:30 PM
Re: 91D restoration - by Guest - 07-04-2010, 01:23 PM
Re: 91D restoration - by Ron Ramirez - 07-04-2010, 01:45 PM
Re: 91D restoration - by Guest - 07-05-2010, 03:34 PM
Re: 91D restoration - by Ron Ramirez - 07-05-2010, 03:38 PM
Re: 91D restoration - by Guest - 07-11-2010, 02:59 PM
Re: 91D restoration - by Ron Ramirez - 07-11-2010, 04:46 PM
Re: 18D restoration - by Guest - 07-11-2010, 08:39 PM
Re: 91D restoration - by Ron Ramirez - 07-11-2010, 09:35 PM
Re: 18D restoration - by Guest - 07-12-2010, 02:14 PM
Re: 18D restoration - by Guest - 07-13-2010, 07:53 PM
Re: 91D restoration - by Ron Ramirez - 07-13-2010, 08:25 PM
Re: 91D restoration - by TexMac - 07-18-2010, 02:31 PM
Re: 18D restoration - by Guest - 07-20-2010, 10:49 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM
RCA 15X
I'd try replacing the bulb first and if that doesn't do it, then change the 35Z5 and see if the problem goes away.NostalgiaRadioTime — 12:28 AM
B&K 1077B no video
Hello Tim, I have that exact unit in my shop too plus a Sencore unit there are times I like one or other !!. Sincerely...radiorich — 11:07 PM
RCA 15X
Everthing goes at once, maybe it's the cold weather, I have had 2 dial strings break and no my little RCA is having dial...Paul Philco322 — 10:26 PM
Philco 91 Schematic
Hi Dan, I can't explain this specific resistor but I have seen the use of a switch to apply B+ voltage to screen gri...RodB — 09:36 PM
6TPZ and 5TPO Radio Help
I suspect it's been repaired before. And I suspect whoever repaired it, wanted to re-use old transistors' pin stubs in o...morzh — 09:24 PM

[-]
Who's Online
There are currently 9587 online users. [Complete List]
» 6 Member(s) | 9581 Guest(s)
AvatarAvatarAvatarAvatar
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration