1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
91D restoration
TexMac
Member
**
Posts: 12
Threads: 0
Joined: Jun 2010
City: Leesburg, TX
#17

07-18-2010, 02:31 PM
Personally, if it were my set, I would just detail clean the brass parts and preserve the patina since the case has just been cleaned and touched up with restor-a-finish. Just my 2 cents worth. I have a 91 and that is my plan, although I have to replace some veneer. My plan is to try to match the old veneer without refinishing it.

edit: oops. Did not realize there was a page 2 and Ron had already made my point better.
Ron Mc/
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
91D restoration - by Guest - 07-02-2010, 04:37 PM
Re: 91D restoration - by Chuck Schwark - 07-03-2010, 01:27 PM
Re: 91D restoration - by Ron Ramirez - 07-04-2010, 08:38 AM
Re: 91D restoration - by Guest - 07-04-2010, 10:50 AM
Re: 91D restoration - by Ron Ramirez - 07-04-2010, 12:30 PM
Re: 91D restoration - by Guest - 07-04-2010, 01:23 PM
Re: 91D restoration - by Ron Ramirez - 07-04-2010, 01:45 PM
Re: 91D restoration - by Guest - 07-05-2010, 03:34 PM
Re: 91D restoration - by Ron Ramirez - 07-05-2010, 03:38 PM
Re: 91D restoration - by Guest - 07-11-2010, 02:59 PM
Re: 91D restoration - by Ron Ramirez - 07-11-2010, 04:46 PM
Re: 18D restoration - by Guest - 07-11-2010, 08:39 PM
Re: 91D restoration - by Ron Ramirez - 07-11-2010, 09:35 PM
Re: 18D restoration - by Guest - 07-12-2010, 02:14 PM
Re: 18D restoration - by Guest - 07-13-2010, 07:53 PM
Re: 91D restoration - by Ron Ramirez - 07-13-2010, 08:25 PM
Re: 91D restoration - by TexMac - 07-18-2010, 02:31 PM
Re: 18D restoration - by Guest - 07-20-2010, 10:49 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM
RCA 15X
I'd try replacing the bulb first and if that doesn't do it, then change the 35Z5 and see if the problem goes away.NostalgiaRadioTime — 12:28 AM
B&K 1077B no video
Hello Tim, I have that exact unit in my shop too plus a Sencore unit there are times I like one or other !!. Sincerely...radiorich — 11:07 PM
RCA 15X
Everthing goes at once, maybe it's the cold weather, I have had 2 dial strings break and no my little RCA is having dial...Paul Philco322 — 10:26 PM
Philco 91 Schematic
Hi Dan, I can't explain this specific resistor but I have seen the use of a switch to apply B+ voltage to screen gri...RodB — 09:36 PM
6TPZ and 5TPO Radio Help
I suspect it's been repaired before. And I suspect whoever repaired it, wanted to re-use old transistors' pin stubs in o...morzh — 09:24 PM

[-]
Who's Online
There are currently 10503 online users. [Complete List]
» 1 Member(s) | 10502 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration