[Ron Ramirez]

A little while ago, I touched up the repaired veneer at the lower front corner of the front panel, and the spot at lower right front where the finish had lifted.

The results:

[Image: http://www.philcoradio.com/images/phorum...-5_118.jpg]

[Image: http://www.philcoradio.com/images/phorum...-5_119.jpg]

Not bad. I think this will do just fine. After some clear lacquer and some wet sanding, it should look somewhat better.

While I was at it, I went ahead and applied the two decals.

So, as a reminder, here is how the cabinet looked to begin with:

[Image: http://www.philcoradio.com/images/phorum...-5_001.jpg]

and how it looks now:

[Image: http://www.philcoradio.com/images/phorum...-5_120.jpg]

[Image: http://www.philcoradio.com/images/phorum...-5_121.jpg]

The next job is to go around the grille openings with brown lacquer, then start spraying on clear lacquer.