1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 89L-troubles
vecher
Phorum Expert
*****
Posts: 933
Threads: 140
Joined: Mar 2015
City: Lansdale State, Province, Country: PA
#31

10-18-2018, 11:09 PM
Ok tried alignment.. Much better.. But noticed the Low end of band is very deaf..from about 600-900 Khz.. It is working since I can inject a signal from SG But levels is very high in order of -20 Dbm..Also noticed that if I put my finger on the RF tube it helps a lot.. Same thing on SW band Signal from Generator can hear but takes a higher signal..

Maybe weak RF tube? The Antenna coil checked out OK.. Not open..

Any clues??

Skip
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Philco 89L-troubles - by vecher - 04-30-2018, 08:41 PM
RE: Philco 89L - by KCMike - 04-30-2018, 09:02 PM
RE: Philco 89L - by Chas - 05-02-2018, 08:27 PM
RE: Philco 89L - by vecher - 06-24-2018, 11:07 AM
RE: Philco 89L - by Radioroslyn - 06-24-2018, 11:49 AM
RE: Philco 89L - by vecher - 06-24-2018, 02:01 PM
RE: Philco 89L - by Radioroslyn - 06-24-2018, 02:57 PM
RE: Philco 89L - by vecher - 06-24-2018, 04:17 PM
RE: Philco 89L - by vecher - 08-03-2018, 11:28 PM
RE: Philco 89L - by Chas - 08-04-2018, 10:44 AM
RE: Philco 89L - by radio63 - 08-14-2018, 08:12 PM
RE: Philco 89L - by Chas - 08-14-2018, 09:39 PM
RE: Philco 89L - by radio63 - 08-15-2018, 03:23 PM
RE: Philco 89L - by jcassity - 08-18-2018, 10:55 AM
RE: Philco 89L - by vecher - 09-09-2018, 12:22 AM
RE: Philco 89L - by Radioroslyn - 09-09-2018, 01:00 AM
RE: Philco 89L - by vecher - 09-09-2018, 04:30 PM
RE: Philco 89L - by Radioroslyn - 09-09-2018, 06:28 PM
RE: Philco 89L - by vecher - 09-09-2018, 11:43 PM
RE: Philco 89L - by morzh - 09-10-2018, 08:37 AM
RE: Philco 89L-Problems - by vecher - 10-17-2018, 05:04 PM
RE: Philco 89L-troubles - by KCMike - 10-17-2018, 05:13 PM
RE: Philco 89L-troubles - by Radioroslyn - 10-17-2018, 05:51 PM
RE: Philco 89L-troubles - by Steve Davis - 10-17-2018, 06:53 PM
RE: Philco 89L-troubles - by vecher - 10-17-2018, 09:09 PM
RE: Philco 89L-troubles - by vecher - 10-17-2018, 10:49 PM
RE: Philco 89L-troubles - by Radioroslyn - 10-17-2018, 11:08 PM
RE: Philco 89L-troubles - by vecher - 10-18-2018, 12:01 PM
RE: Philco 89L-troubles - by vecher - 10-18-2018, 03:16 PM
RE: Philco 89L-troubles - by vecher - 10-18-2018, 08:24 PM
RE: Philco 89L-troubles - by vecher - 10-18-2018, 11:09 PM
RE: Philco 89L-troubles - by Arran - 10-19-2018, 03:12 AM
RE: Philco 89L-troubles - by vecher - 10-19-2018, 01:08 PM
RE: Philco 89L-troubles - by klondike98 - 10-19-2018, 01:13 PM
RE: Philco 89L-troubles - by vecher - 10-19-2018, 02:07 PM
RE: Philco 89L-troubles - by vecher - 10-21-2018, 11:35 PM
RE: Philco 89L-troubles - by vecher - 10-22-2018, 09:17 PM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
Atwater-Kent 84, restoration.
The wires were desoldered from the can, and the capacitors checked. All checked at 0.102 uF, which is correct. So the c...morzh — 09:41 PM
An attempt to remove the Field Coil from a G speaker
Arran Yours probably then the H speaker, same as mine.morzh — 08:39 PM
An attempt to remove the Field Coil from a G speaker
Mike; I would like to have a look at the speaker in my model 96, but the set is packed into a corner in the basement. ...Arran — 08:04 PM
91H Code 126 Restore
Thanks Arran, I'm convinced the power cord is good but have a nice repro plug for it. Would it be prudent to add a fus...RealRider — 07:28 PM
91H Code 126 Restore
As I was studying this schematic I was wondering what does this dotted line means?  I haven't traced it out yet. An o...RealRider — 07:22 PM
91H Code 126 Restore
When it comes to the cloth covered power cords, if they are not frayed, and are flexible, and if I can bend one without ...Arran — 06:21 PM
An attempt to remove the Field Coil from a G speaker
Could be. The central cylinder is OK, but the sides are...well. What's done is done. I wonder if some standard bobbine w...morzh — 06:02 PM
An attempt to remove the Field Coil from a G speaker
Mike; As I was saying it doesn't look like they used much of a bobbin for the field coil, not like a Magnavox one wou...Arran — 05:49 PM
Atwater-Kent 84, restoration.
This AK84 was bought, I think, last fall. For a whopping $100. It has been, according to the seller, restored. As I go ...morzh — 05:48 PM
Philco model 60
Plus I forgot that I have a spare complete Philco FC speaker, that would work perfectly, now that I don’t need it. Got i...Radios1340 — 05:36 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration