Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Picking up a 60L console today
#16

Thank you Ron for the information.  I think I'm going to spiffy up the cabinet and order the grillcloth, then send the speaker off to get reconed then clean up what I can on the chassis and send it somewhere for repair.  It will be nice once it's finished.  Thank you for what you do.


Messages In This Thread
Picking up a 60L console today - by Greggshere - 10-15-2018, 10:36 AM
RE: Picking up a 60L console today - by Ed Locker - 10-15-2018, 02:31 PM
RE: Picking up a 60L console today - by morzh - 10-16-2018, 09:42 AM
RE: Picking up a 60L console today - by marshall70 - 10-27-2018, 12:31 AM
RE: Picking up a 60L console today - by Ed Locker - 11-11-2018, 10:26 AM



Users browsing this thread: 8 Guest(s)
[-]
Recent Posts
6TPZ and 5TPO Radio Help
Yeah, I'm still on 5TPO. Sorry, my bad, points 1 and 2 should be points 18 and 19 (easy mistake  :think: )  X7 is shown ...R3Sons — 11:42 AM
462ron
Hi Levi, here’s just a thought. Most radios run the oscillator higher than the dial setting. Say you set your radio to 1...462ron — 10:10 AM
1930s Stewart-Warner Tombstone Radio need help identifying model number
Another Update: I found a couple of damaged coils inside this radio that might have something to do with why this radio ...captainclock1988 — 10:51 PM
6TPZ and 5TPO Radio Help
If you are still on 5TPO, you lost me there. What X7? What Points 1 and 2?morzh — 08:37 PM
6TPZ and 5TPO Radio Help
Quick progress report: X7 is broken. Only one leg soldered, the other missing and the diode is cracked. I've replaced...R3Sons — 05:05 PM
6TPZ and 5TPO Radio Help
Oh...and you have electrolytic caps there. All need to go and be replaced.morzh — 04:36 PM
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM

[-]
Who's Online
There are currently 3883 online users. [Complete List]
» 1 Member(s) | 3882 Guest(s)
Avatar

>