Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

A Beginner's Journey: The Philco 40-190
#67

From everything I've read, both here and elsewhere, there's no practical difference between axial and radial caps of the same value. As you suspect, it's mostly a matter of what fits best. I've noticed that most restorers prefer the axial tubes, probably because they can stretch quite a ways between components, but I've found that the orange drop radials are very handy in tight quarters, particularly around the RF section of your chassis.

Hope that helps.

Mike


Messages In This Thread
[No subject] - by DeckApe - 07-07-2008, 03:39 PM
[No subject] - by Ron Ramirez - 07-07-2008, 09:45 PM
[No subject] - by DeckApe - 07-08-2008, 07:27 PM
[No subject] - by Michael Dennis - 07-08-2008, 10:14 PM
[No subject] - by DeckApe - 07-09-2008, 12:24 AM
[No subject] - by Michael Dennis - 07-09-2008, 07:05 AM
[No subject] - by DeckApe - 07-17-2008, 12:46 AM
[No subject] - by gary rabbitt - 07-17-2008, 03:04 AM
[No subject] - by DeckApe - 07-17-2008, 11:57 AM
[No subject] - by DeckApe - 07-18-2008, 11:28 PM
[No subject] - by DeckApe - 07-21-2008, 12:38 PM
[No subject] - by DeckApe - 07-24-2008, 11:17 PM
[No subject] - by DeckApe - 07-27-2008, 09:29 PM
[No subject] - by DeckApe - 07-29-2008, 01:16 AM
[No subject] - by BDM - 07-29-2008, 08:56 AM
[No subject] - by DeckApe - 07-29-2008, 12:20 PM
[No subject] - by DeckApe - 08-14-2008, 01:09 AM
[No subject] - by DeckApe - 08-14-2008, 11:48 AM
[No subject] - by Ron Ramirez - 08-14-2008, 10:37 PM
[No subject] - by DeckApe - 08-15-2008, 08:04 AM
[No subject] - by Ron Ramirez - 08-15-2008, 05:30 PM
[No subject] - by DeckApe - 08-16-2008, 03:38 PM
[No subject] - by Ron Ramirez - 08-16-2008, 04:17 PM
[No subject] - by DeckApe - 08-16-2008, 05:02 PM
[No subject] - by DeckApe - 08-21-2008, 01:08 AM
Re: - by Chuck Schwark - 09-07-2008, 10:49 PM
Re: A Beginner's Journey: The Philco 40-190 - by Guest - 09-16-2008, 08:30 PM
Re: A Beginner's Journey: The Philco 40-190 - by Guest - 03-28-2010, 04:08 PM
Re: A Beginner's Journey: The Philco 40-190 - by mgutierres - 10-10-2010, 02:29 PM



Users browsing this thread: 20 Guest(s)
[-]
Recent Posts
The speaker table error?
G  10-1/2"       65, 76, 87, 95 Push-Pull 45's 2766 0.7 550 3200 H   10-1/2"    77, 96 Push-Pull...morzh — 09:26 PM
A Marconi model 86
I have a Stromberg, one of the early ones, seems early 30s. This is what I call a back breaker. None of the early Philc...morzh — 08:28 PM
A Marconi model 86
A backbreaker.....PaulPaul Philco322 — 08:12 PM
A Marconi model 86
>>What a behemoth! A Juggernaut.morzh — 07:47 PM
Philco 70 antenna lead
I am not sure I understood about the coils and the mush. I looked an more than one coil in 20, 70, 90, 60, Zeniths and ...morzh — 07:46 PM
A Marconi model 86
:e_biggrin: What a behemoth!  I hope the final result is as much a quality sounding example!  Keep us posted on your pro...GarySP — 07:32 PM
A Marconi model 86
I should add that the double conversion may only be used on the shortwave bands, but I haven't looked at the schematic t...Arran — 07:27 PM
Philco 70 antenna lead
Yes, that wire will not pick up much interference as routed - the RF at that level won't be affected, and if you have st...radio1 — 07:26 PM
Philco model 60
I'm also a member of MARC. Did you attend the Vintage Electronics Expo in Waterford, MI last month? That's where I got...GarySP — 07:22 PM
A Marconi model 86
Dan Double conversion is using two IF converters instead of one. This improves the image response. morzh — 07:15 PM

[-]
Who's Online
There are currently no members online.

>