Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Farm Radio 38 123
#21

Ok plan B.
Check the tuning cap for bend plates. If there is a bend one most or the time it would be one of the ones on the outside. You also use your ohm meter to measure the resistance across the cap BUT remember that it's in parallel w/ a coil that has a low resistance to start with. With that being said if it has a short it's going to be very low in resistance like something less than 1 ohm or less. Unshorted would be abt 3 or 4 ohms. Either section shorted would give you very poor reception.

The tuning cap is broken down into two sections, one section tunes the antenna circuit and the other tunes the oscillator. I don't have a chassis layout for this set only a diagram, it doesn't tell me which is which. If the cap checks out ok then I would try another 1A6.


As I mentioned before all voltages at the 1A6 look to be what I would expect except for pin 4. Should be a volt or two negative w/a high impedance meter.
No worries there is a plan C.


Happy Hunting!

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
Philco Farm Radio 38 123 - by RCFlyer - 02-21-2019, 01:42 AM
RE: Philco Farm Radio 38 123 - by Radioroslyn - 02-21-2019, 11:26 AM
RE: Philco Farm Radio 38 123 - by RCFlyer - 02-21-2019, 06:27 PM
RE: Philco Farm Radio 38 123 - by Radioroslyn - 02-21-2019, 07:47 PM
RE: Philco Farm Radio 38 123 - by RCFlyer - 02-22-2019, 11:29 PM
RE: Philco Farm Radio 38 123 - by 35Z5 - 02-23-2019, 12:37 AM
RE: Philco Farm Radio 38 123 - by RCFlyer - 02-23-2019, 12:53 AM
RE: Philco Farm Radio 38 123 - by Radioroslyn - 02-23-2019, 01:56 AM
RE: Philco Farm Radio 38 123 - by RCFlyer - 02-23-2019, 02:24 AM
RE: Philco Farm Radio 38 123 - by Stall-U-Rated - 02-23-2019, 02:44 AM
RE: Philco Farm Radio 38 123 - by Arran - 02-23-2019, 05:48 AM
RE: Philco Farm Radio 38 123 - by RCFlyer - 02-24-2019, 12:31 AM
RE: Philco Farm Radio 38 123 - by Radioroslyn - 02-24-2019, 01:18 AM
RE: Philco Farm Radio 38 123 - by RCFlyer - 02-25-2019, 12:40 AM
RE: Philco Farm Radio 38 123 - by Radioroslyn - 02-26-2019, 12:00 AM
RE: Philco Farm Radio 38 123 - by RCFlyer - 02-28-2019, 01:47 AM
RE: Philco Farm Radio 38 123 - by RCFlyer - 02-28-2019, 02:01 AM
RE: Philco Farm Radio 38 123 - by Radioroslyn - 02-28-2019, 11:13 AM
RE: Philco Farm Radio 38 123 - by RCFlyer - 02-28-2019, 03:30 PM
RE: Philco Farm Radio 38 123 - by Radioroslyn - 02-28-2019, 09:40 PM
RE: Philco Farm Radio 38 123 - by RCFlyer - 02-28-2019, 10:04 PM
RE: Philco Farm Radio 38 123 - by Stall-U-Rated - 03-01-2019, 12:23 AM
RE: Philco Farm Radio 38 123 - by RCFlyer - 03-01-2019, 03:02 PM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
462ron
Hi Mike, that 84 sure looks great. You don’t often see these antique radios with a fuse like yours has. I usually instal...462ron — 10:22 AM
Atwater-Kent 84, restoration.
Hello Mike, Wow ! far as my AK it does work and the cabinet is in nice shape so is my chassis anyway here is a photo of...radiorich — 02:59 AM
Atwater-Kent 84, restoration.
Nice radio, Mike! Here's hoping it was well rebuilt. Take care and BE HEALTHY! GaryGarySP — 12:12 AM
Atwater-Kent 84, restoration.
Rich yes, this is the way I got it. I have just put it on the table and took it apart. I suspect it even might work,...morzh — 11:31 PM
Atwater-Kent 84, restoration.
Hello mike, What nice looking radio I have one AK in my collection it's a console I have not started restoring it yet ....radiorich — 11:21 PM
91H Code 126 Restore
Just to make it more confusing here is another model 91 schematic that doesn't show parts with dotted lines in that spot...Arran — 10:37 PM
Atwater-Kent 84, restoration.
The wires were desoldered from the can, and the capacitors checked. All checked at 0.102 uF, which is correct. So the c...morzh — 09:41 PM
An attempt to remove the Field Coil from a G speaker
Arran Yours probably then the H speaker, same as mine.morzh — 08:39 PM
An attempt to remove the Field Coil from a G speaker
Mike; I would like to have a look at the speaker in my model 96, but the set is packed into a corner in the basement. ...Arran — 08:04 PM
91H Code 126 Restore
Thanks Arran, I'm convinced the power cord is good but have a nice repro plug for it. Would it be prudent to add a fus...RealRider — 07:28 PM

[-]
Who's Online
There are currently 4796 online users. [Complete List]
» 2 Member(s) | 4794 Guest(s)
AvatarAvatar

>