Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

42-340 Dial String
#1

Folks, am new to the forum but am working on a 42-340, have stuffed the caps and its playing well, but am having a hard time on the dial string. Its a two string system that is seperated, there are two wheels (pulleys) on the tuner, the large outside one drives the tuner dial and the inside wheel is driven by tuning knob. with the tuner dial string disconnected its works great, but put the tuner dial string back on and it won't turn the tuner, it just slips and have treated it with some craft store mat placment glue, so it's a little sticky. Did the small pulley on the end of the dial string arragement have a plastic or bakelite bushing in it at one time.

Any ideas or suggestions will be appreicated.

Larry


Messages In This Thread
42-340 Dial String - by Larry Morrow - 11-17-2010, 07:01 PM
Re: 42-340 Dial String - by Glenn Roberts - 11-18-2010, 07:53 AM
Re: 42-340 Dial String - by Larry Morrow - 11-18-2010, 01:34 PM
Re: 42-340 Dial String - by Ron Ramirez - 11-18-2010, 09:18 PM
Re: 42-340 Dial String - by Glenn Roberts - 11-19-2010, 04:21 PM
Re: 42-340 Dial String - by Larry Morrow - 11-19-2010, 11:00 PM
Re: 42-340 Dial String - by Larry Morrow - 11-20-2010, 08:38 PM
Re: 42-340 Dial String - by Glenn Roberts - 11-21-2010, 05:25 PM
Re: 42-340 Dial String - by Larry Morrow - 11-22-2010, 12:48 AM
Re: 42-340 Dial String - by Larry Morrow - 11-25-2010, 12:48 PM
Re: 42-340 Dial String - by Glenn Roberts - 11-25-2010, 04:39 PM
Re: 42-340 Dial String - by Larry Morrow - 11-28-2010, 01:19 AM
Re: 42-340 Dial String - by Glenn Roberts - 11-28-2010, 07:06 AM
Re: 42-340 Dial String - by Larry Morrow - 11-28-2010, 12:49 PM
Re: 42-340 Dial String - by Glenn Roberts - 11-29-2010, 06:37 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
An attempt to remove the Field Coil from a G speaker
Gary I in fact did, on a 38-14, I think, where I had a speaker with the dead coil. Well...it kinda worked. Kinda, be...morzh — 10:38 PM
An attempt to remove the Field Coil from a G speaker
Mike, what ever happened to that plan you had to try using a rare earth magnet to magnetize the pole? This looks like a...GarySP — 10:25 PM
RCA T62 is playing.....
Beautiful set.morzh — 09:07 PM
An attempt to remove the Field Coil from a G speaker
Well....here it is. The green stuff. Unfortunately, probably penetrates deep. I opened the top layer and saw that: ...morzh — 08:58 PM
Philco 91 Restore Code ??
:clap: :clap: :clap: :clap: Really nice workmanship!!! Top of the chassis looks great. Sorry about the long winded e...MrFixr55 — 08:09 PM
Philco 40-120C Restoration
Thank you for your reply. I will check voltages on the other tubes, look at resistor 23 and cap 25, etc. If all else fai...bluecap — 07:58 PM
RCA T62 is playing.....
Nice looking set great save. DavidDavid — 07:48 PM
Philco 89 indicator light.
Hello Jim, I have done several 89s. The trick is to move the drum in or out on it's shaft. You will need to loosen a set...dconant — 07:36 PM
An attempt to remove the Field Coil from a G speaker
MrFixr Yes, it is my plan to go with 45rpm spider if I go that far. No, the pole was not left-handed as I unscrewed ...morzh — 07:14 PM
Philco 40-120C Restoration
Change the tube. Check the tube's bias network. Are any other tubes experience the drop or just this?` Is resistor 23 OK...morzh — 07:09 PM

[-]
Who's Online
There are currently no members online.

>