Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Looking for a communications receiver?
#19

Ron,

Hammarlund made great receivers. Yes the HQ170 is Ham only and the HQ180 is general coverage. There is also a HQ-180A that has a solid state rectifier. The HQ180C has a built in clock. There is a person that sells a frequency readout unit that fits where the clock is.  I've had a restored HQ180C for years and it is very sensitive. I like Hammarlund radios so much that I recently purchased a Hammarlund SP-600 which I recapped and had a friend align earlier this year. I still need to clean up the front and paint the two dial lens black as someone painted them blue. I'm going to have the cabinet sandblasted and powder coated the original gray. I've only used it for a month but found that it is an exceptional performer as well. About 10 years ago I had a HQ145 and it was a real performer too. I have 3 solid state radios but find myself using the vintage tube radios the most. Collins and Hammarlund are my favorite tube receivers. There is very little that my best solid state radio can hear that the HQ180 can't, which shows how well designed they were. I rarely listen to SW and have been DX'ing MW for the last 10 years using a wellbrook loop. There is still quite a bit of SW activity if you have a really good antenna. 

I'm moving my radio room into a spare bedroom so my radios are out of commision for now until I move the antennas and electrical. I waited for Summer to move things as Winter has the best DX and I'll have them back and going by then.

Here are the two Hammarlunds....

   

   


Messages In This Thread
RE: Looking for a communications receiver? - by thirtiesradio - 08-04-2019, 01:50 AM



Users browsing this thread: 8 Guest(s)
[-]
Recent Posts
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM
RCA 15X
I'd try replacing the bulb first and if that doesn't do it, then change the 35Z5 and see if the problem goes away.NostalgiaRadioTime — 12:28 AM
B&K 1077B no video
Hello Tim, I have that exact unit in my shop too plus a Sencore unit there are times I like one or other !!. Sincerely...radiorich — 11:07 PM
RCA 15X
Everthing goes at once, maybe it's the cold weather, I have had 2 dial strings break and no my little RCA is having dial...Paul Philco322 — 10:26 PM
Philco 91 Schematic
Hi Dan, I can't explain this specific resistor but I have seen the use of a switch to apply B+ voltage to screen gri...RodB — 09:36 PM

[-]
Who's Online
There are currently 10220 online users. [Complete List]
» 1 Member(s) | 10219 Guest(s)
Avatar

>