Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

51-1733 alignment questions
#13

https://philcoradio.com/library/download...-final.pdf Seems pretty clear to me. NA is awful!!

Don't really care about what the Sam's sez values or placement. It just confuses things. The resistor a cap you mention are in the cathode circuit of the oscillator. They vary the gain of the oscillator tube. They are not a frequency determining components.

I'm thinking they something wrong w/the IF alignment. You shouldn't have to bottom out the slugs. A few things to check. Frequency with a counter @455kc. With the generator set up at 455kc and connect up. Move the dial on the Philco and if the signal disappears you were not on the IF frequency. Always when doing an alignment keep the generator level to a minimum. This means so you can just barely hear it then peak up the adjustment. turn the generator down till you get all of the 455kc transformers peaked up. I usually go over them a couple of times to be sure. Having the generator level up can cause the avc to lower the gain of the tubes in the avc line.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
51-1733 alignment questions - by Wilryn - 05-10-2020, 03:25 PM
RE: 51-1733 alignment questions - by Radioroslyn - 05-10-2020, 08:59 PM
RE: 51-1733 alignment questions - by Wilryn - 05-10-2020, 11:23 PM
RE: 51-1733 alignment questions - by Wilryn - 05-11-2020, 12:16 AM
RE: 51-1733 alignment questions - by Wilryn - 05-11-2020, 08:55 AM
RE: 51-1733 alignment questions - by RodB - 05-11-2020, 11:45 AM
RE: 51-1733 alignment questions - by Wilryn - 05-11-2020, 04:29 PM
RE: 51-1733 alignment questions - by Radioroslyn - 05-11-2020, 08:02 PM
RE: 51-1733 alignment questions - by Wilryn - 05-12-2020, 02:39 PM
RE: 51-1733 alignment questions - by Wilryn - 05-13-2020, 12:21 PM
RE: 51-1733 alignment questions - by Radioroslyn - 05-13-2020, 02:40 PM
RE: 51-1733 alignment questions - by Wilryn - 05-13-2020, 05:50 PM
RE: 51-1733 alignment questions - by Radioroslyn - 05-13-2020, 08:12 PM
RE: 51-1733 alignment questions - by Wilryn - 05-14-2020, 06:31 PM
RE: 51-1733 alignment questions - by Radioroslyn - 05-14-2020, 07:25 PM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
Philco 46-480 Electronic Restoration
I kept working on reassembly this week. I wasn’t able to solder for a few days while it was too cold (single digit low t...jrblasde — 09:27 PM
Atwater-Kent 84, restoration.
Well, powering it up would be too good to be true, and I had that feeling. Before I did, I decided to check the coils...morzh — 06:02 PM
An attempt to remove the Field Coil from a G speaker
Thanks Chas, sure will give it a look!morzh — 03:39 PM
An attempt to remove the Field Coil from a G speaker
Mike, Lookup  murrayatuptown on ARF. Seems he has a dilemma with surplus field coils. Could get lucky and have what y...Chas — 01:26 PM
Atwater-Kent 84, restoration.
Hello Mike, I have not checked to see if my console has a fuse or not and far as sets go I have early 30s General Motor...radiorich — 11:25 AM
Atwater-Kent 84, restoration.
Ron I forgot, but when you said "phone number", I remembered, caus I usually remember how I act when I need...morzh — 11:12 AM
Atwater-Kent 84, restoration.
You have an extensive collection of Philcos, Mike! I’m always excited to see each new one. Agreed on the power supply fu...jrblasde — 10:50 AM
462ron
Hi Mike, that 84 sure looks great. You don’t often see these antique radios with a fuse like yours has. I usually instal...462ron — 10:22 AM
Atwater-Kent 84, restoration.
Hello Mike, Wow ! far as my AK it does work and the cabinet is in nice shape so is my chassis anyway here is a photo of...radiorich — 02:59 AM
Atwater-Kent 84, restoration.
Nice radio, Mike! Here's hoping it was well rebuilt. Take care and BE HEALTHY! GaryGarySP — 12:12 AM

[-]
Who's Online
There are currently no members online.

>