08-26-2020, 09:30 PM
https://philcoradio.com/library/download...8-1949.pdf
> It is 174 ohms instead of 165 is it ok for a first testing or I need to change it?
Nah your <10%.
>What is correct the schematic or the cabling I have on the radio?
Pins 2 and 8 are at the same + positive in regards to the chassis ground. Do not short the two pins together as there is 5v@2a across them. Using pin 2 or 8 as a high volt point is fine so either wiring is ok as per the schematic.
> It is 174 ohms instead of 165 is it ok for a first testing or I need to change it?
Nah your <10%.
>What is correct the schematic or the cabling I have on the radio?
Pins 2 and 8 are at the same + positive in regards to the chassis ground. Do not short the two pins together as there is 5v@2a across them. Using pin 2 or 8 as a high volt point is fine so either wiring is ok as per the schematic.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
