1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
41-285 troubleshooting help
jstaf40
Junior Member
**
Posts: 43
Threads: 21
Joined: Nov 2010
City: hesperia,ca.92345
#6

05-06-2011, 01:11 PM
when i inject a signal to the 2nd IF pin 2 clear signal at pin 6 it starts to distorted a little when i get to 1st IF pin 2 its vary distorted and the signal stops there, i have ck wiring and so far i haven't found a mistake, it had a lot of rubber wire i replaced it all, i could have hooked it up one wrong i am still checking it out.. all the radios i have restored have been in working condition so it was easy to do, this one was broke when i got it so its still a mystery
thank you again all the members have been generous with there time.. thanks again
john
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
41-285 troubleshooting help - by jstaf40 - 05-03-2011, 08:21 PM
Re: 41-285 troubleshooting help - by 7estatdef - 05-03-2011, 09:52 PM
Re: 41-285 troubleshooting help - by jstaf40 - 05-04-2011, 09:25 PM
Re: 41-285 troubleshooting help - by 7estatdef - 05-04-2011, 09:43 PM
Re: 41-285 troubleshooting help - by jstaf40 - 05-06-2011, 01:11 PM
Re: 41-285 troubleshooting help - by 7estatdef - 05-06-2011, 05:49 PM
Re: 41-285 troubleshooting help - by jstaf40 - 05-07-2011, 04:42 PM
Re: 41-285 troubleshooting help - by 7estatdef - 05-07-2011, 09:21 PM
Re: 41-285 troubleshooting help - by jstaf40 - 05-09-2011, 05:26 PM
Re: 41-285 troubleshooting help - by 7estatdef - 05-09-2011, 06:19 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
The speaker table error?
G  10-1/2"       65, 76, 87, 95 Push-Pull 45's 2766 0.7 550 3200 H   10-1/2"    77, 96 Push-Pull...morzh — 09:26 PM
A Marconi model 86
I have a Stromberg, one of the early ones, seems early 30s. This is what I call a back breaker. None of the early Philc...morzh — 08:28 PM
A Marconi model 86
A backbreaker.....PaulPaul Philco322 — 08:12 PM
A Marconi model 86
>>What a behemoth! A Juggernaut.morzh — 07:47 PM
Philco 70 antenna lead
I am not sure I understood about the coils and the mush. I looked an more than one coil in 20, 70, 90, 60, Zeniths and ...morzh — 07:46 PM
A Marconi model 86
:e_biggrin: What a behemoth!  I hope the final result is as much a quality sounding example!  Keep us posted on your pro...GarySP — 07:32 PM
A Marconi model 86
I should add that the double conversion may only be used on the shortwave bands, but I haven't looked at the schematic t...Arran — 07:27 PM
Philco 70 antenna lead
Yes, that wire will not pick up much interference as routed - the RF at that level won't be affected, and if you have st...radio1 — 07:26 PM
Philco model 60
I'm also a member of MARC. Did you attend the Vintage Electronics Expo in Waterford, MI last month? That's where I got...GarySP — 07:22 PM
A Marconi model 86
Dan Double conversion is using two IF converters instead of one. This improves the image response. morzh — 07:15 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration