Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Stewart-Warner A72T3
#13

>If you don't have an FM generator an AM generator will do in a pinch. Just use an unmodulated 10.7MHz carrier to the FM antenna with a high impedance meter attached to 6AQ6 pin 6 to read a negative voltage. This voltage is the AGC voltage and varies depending on signal strength, which can be changed from the signal generator. If you get the AGC to vary with signal strength from the antenna the FM oscillator is probably not working. Otherwise one of the FM tubes may be bad; it's been my experience the FM RF amplifier. Double check any parts you replaced in the FM section. Do not change any of the settings until after you find and fix the culprit.

What were the results?

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
Stewart-Warner A72T3 - by Masonparker - 07-23-2022, 01:32 PM
RE: Stewart-Warner A72T3 - by Paul Philco322 - 07-23-2022, 01:45 PM
RE: Stewart-Warner A72T3 - by David - 07-23-2022, 04:54 PM
RE: Stewart-Warner A72T3 - by RodB - 07-23-2022, 05:30 PM
RE: Stewart-Warner A72T3 - by morzh - 07-23-2022, 07:27 PM
RE: Stewart-Warner A72T3 - by Masonparker - 07-23-2022, 08:33 PM
RE: Stewart-Warner A72T3 - by Radioroslyn - 07-23-2022, 08:56 PM
RE: Stewart-Warner A72T3 - by David - 07-23-2022, 09:17 PM
RE: Stewart-Warner A72T3 - by MrFixr55 - 07-23-2022, 09:22 PM
RE: Stewart-Warner A72T3 - by Masonparker - 07-24-2022, 06:54 AM
RE: Stewart-Warner A72T3 - by morzh - 07-24-2022, 10:19 AM
RE: Stewart-Warner A72T3 - by Masonparker - 07-29-2022, 04:19 PM
RE: Stewart-Warner A72T3 - by Radioroslyn - 07-30-2022, 08:01 AM
RE: Stewart-Warner A72T3 - by Masonparker - 11-29-2022, 10:07 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
462ron
OK, I need to rename this thread to say..Eico 368 TV/FM Sweep Generator instead of the current title..Heathkit Sweep Gen...462ron — 12:49 PM
6TPZ and 5TPO Radio Help
Hello, I have a Philco (Ford) 6TPZ and a 5TPO radio.  I replaced the electrolytic capacitors in both.  I have the SAMS m...R3Sons — 12:29 PM
The list of my radio & TV collection!
Hello Peter, Thank you for posting that !! Sincerely Richardradiorich — 09:40 AM
Eico 232 VTVM Schematic
It's a microwave antenna. ?;-p?. I substituted 1N4002s off the 6.3 vac winding for the 1.5 volt battery. Uniprobe is the...RodB — 05:50 PM
Eico 232 VTVM Schematic
Try BAMA for a schematic. Looks like a replacement power source for the D battery has been installed. The tube may be...Chas — 04:51 PM
Eico 232 VTVM Schematic
Is that a battery holder?morzh — 04:43 PM
Eico 232 VTVM Schematic
A friend gave me this Eico 232 VTVM and I'm having trouble locating the schematic for it. This one seems to be a later v...RodB — 04:17 PM
Var resistor id
Considering what it is in series with, I doubt there should be any power requirements. Of course, we should know wher...morzh — 03:23 PM
Var resistor id
Trim pot, about 1/2 watt part of focus divider. As stated 2k ohms. This appears to be a rusty chassis, resolder all ...Chas — 03:19 PM
Var resistor id
Its a Sylvania 400 oscilloscope. here is a clip of r-100. Would be nice to know the current required. Not listed in part...Martinj — 02:10 PM

[-]
Who's Online
There are currently 8839 online users. [Complete List]
» 3 Member(s) | 8836 Guest(s)
AvatarAvatarAvatar

>