Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

37-116 Period Correct Wiring
#5

Just no telling what color they will fade to. After all did you think you would have the same color hair you did all that time ago, if you still have some? Me neither. Once again green was the 6.3 winding, yellow was the 5.0 winding, and red was the high voltage winding. Center taps were usually staggared colors, sometimes the 6.3 had a yellow trail, the cener tap of the 5 volt winding may or may not be be present, and could be any color, but the b+ enter tap almost always had a varigated color scheme. You can always take out all the tubes, and fire the set up, and measure what you find. All will be up a little bit, maybe a lot,because there is no load applied.

Put a 1 Ampere fuse ahead of the transformer before doing any measurements. Tell us wyat you have found.


Messages In This Thread
37-116 Period Correct Wiring - by qanerd - 06-21-2011, 04:57 PM
Re: 37-116 Period Correct Wiring - by Arran - 06-21-2011, 09:01 PM
Re: 37-116 Period Correct Wiring - by codefox1 - 06-21-2011, 10:45 PM
Re: 37-116 Period Correct Wiring - by qanerd - 06-21-2011, 11:41 PM
Re: 37-116 Period Correct Wiring - by codefox1 - 06-22-2011, 12:19 AM
Re: 37-116 Period Correct Wiring - by qanerd - 06-22-2011, 12:51 PM
Re: 37-116 Period Correct Wiring - by exray - 06-22-2011, 01:44 PM
Re: 37-116 Period Correct Wiring - by qanerd - 06-22-2011, 03:11 PM
Re: 37-116 Period Correct Wiring - by exray - 06-22-2011, 03:46 PM
Re: 37-116 Period Correct Wiring - by qanerd - 06-22-2011, 04:10 PM
Re: 37-116 Period Correct Wiring - by Arran - 06-22-2011, 05:58 PM
Re: 37-116 Period Correct Wiring - by qanerd - 06-22-2011, 11:44 PM



Users browsing this thread: 6 Guest(s)
[-]
Recent Posts
The speaker table error?
G  10-1/2"       65, 76, 87, 95 Push-Pull 45's 2766 0.7 550 3200 H   10-1/2"    77, 96 Push-Pull...morzh — 09:26 PM
A Marconi model 86
I have a Stromberg, one of the early ones, seems early 30s. This is what I call a back breaker. None of the early Philc...morzh — 08:28 PM
A Marconi model 86
A backbreaker.....PaulPaul Philco322 — 08:12 PM
A Marconi model 86
>>What a behemoth! A Juggernaut.morzh — 07:47 PM
Philco 70 antenna lead
I am not sure I understood about the coils and the mush. I looked an more than one coil in 20, 70, 90, 60, Zeniths and ...morzh — 07:46 PM
A Marconi model 86
:e_biggrin: What a behemoth!  I hope the final result is as much a quality sounding example!  Keep us posted on your pro...GarySP — 07:32 PM
A Marconi model 86
I should add that the double conversion may only be used on the shortwave bands, but I haven't looked at the schematic t...Arran — 07:27 PM
Philco 70 antenna lead
Yes, that wire will not pick up much interference as routed - the RF at that level won't be affected, and if you have st...radio1 — 07:26 PM
Philco model 60
I'm also a member of MARC. Did you attend the Vintage Electronics Expo in Waterford, MI last month? That's where I got...GarySP — 07:22 PM
A Marconi model 86
Dan Double conversion is using two IF converters instead of one. This improves the image response. morzh — 07:15 PM

[-]
Who's Online
There are currently 6091 online users. [Complete List]
» 1 Member(s) | 6090 Guest(s)
Avatar

>