Model 650 Tone Control Question
Posts: 7,294
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
Heathkit got a deal on those 12BY7's. Back in the mid 1950's they use them as the audio driver tube for the modulator section in their 100 watt class AM transmitter the DX-100. P/P1625 (12v 807's) which will make about 120w class ab2. It's transformer coupled and is grid biased from the hv power supply. You'll note that there are two 1/10 of an ohm resistors in the cathode circuit of the 1625's. These are not for biasing but are meter shunts.
https://archive.org/details/heathkit_dx-100_manual
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
Messages In This Thread
RE: Model 650 Tone Control Question - by Radioroslyn - 07-13-2023, 06:07 PM
Users browsing this thread: 1 Guest(s)
|
Recent Posts
|
6TPZ and 5TPO Radio Help
|
Welcome to the Phorum, R3Sons! I have very limited experience with car radios other than installing custom radios back ...GarySP — 01:08 PM |
462ron
|
OK, I need to rename this thread to say..Eico 368 TV/FM Sweep Generator instead of the current title..Heathkit Sweep Gen...462ron — 12:49 PM |
6TPZ and 5TPO Radio Help
|
Hello, I have a Philco (Ford) 6TPZ and a 5TPO radio. I replaced the electrolytic capacitors in both. I have the SAMS m...R3Sons — 12:29 PM |
The list of my radio & TV collection!
|
Hello Peter,
Thank you for posting that !!
Sincerely Richardradiorich — 09:40 AM |
Eico 232 VTVM Schematic
|
It's a microwave antenna. ?;-p?. I substituted 1N4002s off the 6.3 vac winding for the 1.5 volt battery. Uniprobe is the...RodB — 05:50 PM |
Eico 232 VTVM Schematic
|
Try BAMA for a schematic.
Looks like a replacement power source for the D battery has been installed. The tube may be...Chas — 04:51 PM |
Eico 232 VTVM Schematic
|
Is that a battery holder?morzh — 04:43 PM |
Eico 232 VTVM Schematic
|
A friend gave me this Eico 232 VTVM and I'm having trouble locating the schematic for it. This one seems to be a later v...RodB — 04:17 PM |
Var resistor id
|
Considering what it is in series with, I doubt there should be any power requirements. Of course, we should
know wher...morzh — 03:23 PM |
Var resistor id
|
Trim pot, about 1/2 watt part of focus divider. As stated 2k ohms.
This appears to be a rusty chassis, resolder all ...Chas — 03:19 PM |
Who's Online
|
There are currently 6448 online users. [Complete List] » 1 Member(s) | 6447 Guest(s)
|
|
|
![>](https://philcoradio.com/phorum/images/bootbb/asb/right_arrow.png)
|