Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Crosley 655 RF problems
#6

"You state that you "get strong IF oscillations from antenna to speaker". Do you mean that you injected a 450KHz signal with 400Hz modulation from a signal generator?" 

Without the generator?

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
Crosley 655 RF problems - by Patrick - 11-18-2023, 10:32 AM
RE: Crosley 655 RF problems - by Patrick - 12-12-2023, 09:33 AM
RE: Crosley 655 RF problems - by Radioroslyn - 12-12-2023, 11:52 AM
RE: Crosley 655 RF problems - by MrFixr55 - 12-13-2023, 10:47 PM
RE: Crosley 655 RF problems - by Patrick - 12-14-2023, 01:56 PM
RE: Crosley 655 RF problems - by Radioroslyn - 12-14-2023, 07:13 PM
RE: Crosley 655 RF problems - by Patrick - 12-14-2023, 10:42 PM
RE: Crosley 655 RF problems - by EdHolland - 12-15-2023, 04:41 PM
RE: Crosley 655 RF problems - by Radioroslyn - 12-15-2023, 08:10 PM
RE: Crosley 655 RF problems - by Patrick - 12-16-2023, 09:18 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
6TPZ and 5TPO Radio Help
Welcome to the Phorum, R3Sons! I have very limited experience with car radios other than installing custom radios back ...GarySP — 01:08 PM
462ron
OK, I need to rename this thread to say..Eico 368 TV/FM Sweep Generator instead of the current title..Heathkit Sweep Gen...462ron — 12:49 PM
6TPZ and 5TPO Radio Help
Hello, I have a Philco (Ford) 6TPZ and a 5TPO radio.  I replaced the electrolytic capacitors in both.  I have the SAMS m...R3Sons — 12:29 PM
The list of my radio & TV collection!
Hello Peter, Thank you for posting that !! Sincerely Richardradiorich — 09:40 AM
Eico 232 VTVM Schematic
It's a microwave antenna. ?;-p?. I substituted 1N4002s off the 6.3 vac winding for the 1.5 volt battery. Uniprobe is the...RodB — 05:50 PM
Eico 232 VTVM Schematic
Try BAMA for a schematic. Looks like a replacement power source for the D battery has been installed. The tube may be...Chas — 04:51 PM
Eico 232 VTVM Schematic
Is that a battery holder?morzh — 04:43 PM
Eico 232 VTVM Schematic
A friend gave me this Eico 232 VTVM and I'm having trouble locating the schematic for it. This one seems to be a later v...RodB — 04:17 PM
Var resistor id
Considering what it is in series with, I doubt there should be any power requirements. Of course, we should know wher...morzh — 03:23 PM
Var resistor id
Trim pot, about 1/2 watt part of focus divider. As stated 2k ohms. This appears to be a rusty chassis, resolder all ...Chas — 03:19 PM

[-]
Who's Online
There are currently 8742 online users. [Complete List]
» 3 Member(s) | 8739 Guest(s)
AvatarAvatarAvatar

>