1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Restoring a Model 89-123 I think
brodie
Junior Member
**
Posts: 5
Threads: 2
Joined: Oct 2011
#1

10-19-2011, 05:24 PM
Hello everyone. I have a Model 89-123. It says this on the rear of the chassis. So, I went to Nostaliair on got a copy of the specs. I have now replaced all paper caps with new ones acorrding to the specs. Now I find out that this radio uses a 36 tube instead of a 77 that is on the print. Looking more closely I think this is a model 89B. Is there any changes in capacitors (cap blocks) or resistors that have to be changed from the 77 tube to the 36. This radio has 4 knobs as I understand there was a change when they added short wave and put the on off switch to the the same. The specs I have looked at are very hard to read, or very confusing. What I need is a cross reference from the new version to the old. Hope someone can help! Thanks
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Restoring a Model 89-123 I think - by brodie - 10-19-2011, 05:24 PM
Re: Restoring a Model 89-123 I think - by brodie - 10-19-2011, 06:22 PM
Re: Restoring a Model 89-123 I think - by brodie - 10-19-2011, 08:55 PM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
The speaker table error?
G  10-1/2"       65, 76, 87, 95 Push-Pull 45's 2766 0.7 550 3200 H   10-1/2"    77, 96 Push-Pull...morzh — 09:26 PM
A Marconi model 86
I have a Stromberg, one of the early ones, seems early 30s. This is what I call a back breaker. None of the early Philc...morzh — 08:28 PM
A Marconi model 86
A backbreaker.....PaulPaul Philco322 — 08:12 PM
A Marconi model 86
>>What a behemoth! A Juggernaut.morzh — 07:47 PM
Philco 70 antenna lead
I am not sure I understood about the coils and the mush. I looked an more than one coil in 20, 70, 90, 60, Zeniths and ...morzh — 07:46 PM
A Marconi model 86
:e_biggrin: What a behemoth!  I hope the final result is as much a quality sounding example!  Keep us posted on your pro...GarySP — 07:32 PM
A Marconi model 86
I should add that the double conversion may only be used on the shortwave bands, but I haven't looked at the schematic t...Arran — 07:27 PM
Philco 70 antenna lead
Yes, that wire will not pick up much interference as routed - the RF at that level won't be affected, and if you have st...radio1 — 07:26 PM
Philco model 60
I'm also a member of MARC. Did you attend the Vintage Electronics Expo in Waterford, MI last month? That's where I got...GarySP — 07:22 PM
A Marconi model 86
Dan Double conversion is using two IF converters instead of one. This improves the image response. morzh — 07:15 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration