1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Restoring 38-7CS cabinet
Bob Andersen
Phorum Expert
*****
Posts: 802
Threads: 42
Joined: Dec 2008
City: Chicago, IL
#9

01-01-2012, 04:55 PM
peterc Wrote:2. any tricks to disassembling the electronics and speaker from the cabinet? I haven't even looked under there except to verify that it is a 38-7CS.

As I recall there are four small bolts holding the speaker on. Remove the nuts from the back while being careful not to damage the speaker cone. The chassis is mounted at a right angle and bolted to the underside of the top. I used a rachet wrench with extension to get up in there.

Good luck.
Website Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Restoring 38-7CS cabinet - by peterc - 12-14-2011, 10:22 AM
Re: Restoring 38-7CS cabinet - by Bob Andersen - 12-16-2011, 12:58 PM
Re: Restoring 38-7CS cabinet - by peterc - 12-17-2011, 09:08 AM
Re: Restoring 38-7CS cabinet - by Ron Ramirez - 12-17-2011, 09:50 AM
Re: Restoring 38-7CS cabinet - by Bob Andersen - 12-17-2011, 08:29 PM
Re: Restoring 38-7CS cabinet - by peterc - 12-28-2011, 10:21 PM
Re: Restoring 38-7CS cabinet - by LASJayhawk - 12-29-2011, 03:03 AM
Re: Restoring 38-7CS cabinet - by peterc - 12-29-2011, 10:35 AM
Re: Restoring 38-7CS cabinet - by Bob Andersen - 01-01-2012, 04:55 PM
Re: Restoring 38-7CS cabinet - by peterc - 01-02-2012, 10:04 PM
Re: Restoring 38-7CS cabinet - by fixinmyphilco - 01-19-2012, 08:05 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM
RCA 15X
I'd try replacing the bulb first and if that doesn't do it, then change the 35Z5 and see if the problem goes away.NostalgiaRadioTime — 12:28 AM
B&K 1077B no video
Hello Tim, I have that exact unit in my shop too plus a Sencore unit there are times I like one or other !!. Sincerely...radiorich — 11:07 PM
RCA 15X
Everthing goes at once, maybe it's the cold weather, I have had 2 dial strings break and no my little RCA is having dial...Paul Philco322 — 10:26 PM
Philco 91 Schematic
Hi Dan, I can't explain this specific resistor but I have seen the use of a switch to apply B+ voltage to screen gri...RodB — 09:36 PM

[-]
Who's Online
There are currently 6699 online users. [Complete List]
» 2 Member(s) | 6697 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration