1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 41-280
OldJack1969
Junior Member
**
Posts: 21
Threads: 3
Joined: Dec 2011
City: North Las Vegas, NV
#3

01-04-2012, 06:55 PM
7estatdef Wrote:Nah that cap is not going to do it. Triple check your wiring of the caps that you replaced and any bad rubber wire. Make sure you've got plate and screen grid voltage on the 41's
Terry

Sorry, but I'm not electronically inclined...I'm not sure what you mean by having plate and screen grid voltage on the 41's... after replacing the capacitors, I have better volume, but still have distortion. I also found that there were 2 resistors connected to the 41 sockets that were suppose to be 1 Megohm, and actually was 1.341 and 1.234 ohms... so in the middle of ordering new ones. That cap I was talking about, is also connected to both 41 sockets, pin 2, that's why I'm changing it..
I will double check all the wires again and replace as necessary..
If you can, let me know how to check plate and grid voltage if that's not too much trouble.. thanks.
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Philco 41-280 - by OldJack1969 - 01-03-2012, 07:08 PM
Re: Philco 41-280 - by 7estatdef - 01-03-2012, 08:52 PM
Re: Philco 41-280 - by OldJack1969 - 01-04-2012, 06:55 PM
Re: Philco 41-280 - by 7estatdef - 01-04-2012, 11:49 PM
Re: Philco 41-280 - by OldJack1969 - 01-05-2012, 12:00 AM
Re: Philco 41-280 - by OldJack1969 - 01-05-2012, 01:09 AM
Re: Philco 41-280 - by 7estatdef - 01-05-2012, 07:28 PM
Re: Philco 41-280 - by OldJack1969 - 01-05-2012, 08:25 PM
Re: Philco 41-280 - by 7estatdef - 01-05-2012, 11:28 PM
Re: Philco 41-280 - by OldJack1969 - 01-06-2012, 12:05 AM
Re: Philco 41-280 - by 7estatdef - 01-06-2012, 08:47 AM
Re: Philco 41-280 - by OldJack1969 - 01-06-2012, 01:35 PM
Re: Philco 41-280 - by 7estatdef - 01-06-2012, 05:42 PM
Re: Philco 41-280 - by OldJack1969 - 01-08-2012, 12:43 AM
Re: Philco 41-280 - by Phlogiston - 01-08-2012, 12:56 AM
Re: Philco 41-280 - by OldJack1969 - 01-08-2012, 01:10 AM
Re: Philco 41-280 - by 7estatdef - 01-08-2012, 03:30 PM
Re: Philco 41-280 - by OldJack1969 - 01-08-2012, 03:45 PM
Re: Philco 41-280 - by gary rabbitt - 01-23-2012, 08:38 PM
Re: Philco 41-280 - by OldJack1969 - 01-23-2012, 09:29 PM
Re: Philco 41-280 - by gary rabbitt - 01-24-2012, 04:58 PM
Re: Philco 41-280 - by OldJack1969 - 01-24-2012, 05:10 PM
Re: Philco 41-280 - by 7estatdef - 01-24-2012, 06:17 PM
Re: Philco 41-280 - by OldJack1969 - 01-24-2012, 06:50 PM
Re: Philco 41-280 - by 7estatdef - 01-24-2012, 06:56 PM
Re: Philco 41-280 - by OldJack1969 - 01-24-2012, 07:15 PM



Users browsing this thread: 9 Guest(s)
[-]
Recent Posts
Atwater-Kent 84, restoration.
The wires were desoldered from the can, and the capacitors checked. All checked at 0.102 uF, which is correct. So the c...morzh — 09:41 PM
An attempt to remove the Field Coil from a G speaker
Arran Yours probably then the H speaker, same as mine.morzh — 08:39 PM
An attempt to remove the Field Coil from a G speaker
Mike; I would like to have a look at the speaker in my model 96, but the set is packed into a corner in the basement. ...Arran — 08:04 PM
91H Code 126 Restore
Thanks Arran, I'm convinced the power cord is good but have a nice repro plug for it. Would it be prudent to add a fus...RealRider — 07:28 PM
91H Code 126 Restore
As I was studying this schematic I was wondering what does this dotted line means?  I haven't traced it out yet. An o...RealRider — 07:22 PM
91H Code 126 Restore
When it comes to the cloth covered power cords, if they are not frayed, and are flexible, and if I can bend one without ...Arran — 06:21 PM
An attempt to remove the Field Coil from a G speaker
Could be. The central cylinder is OK, but the sides are...well. What's done is done. I wonder if some standard bobbine w...morzh — 06:02 PM
An attempt to remove the Field Coil from a G speaker
Mike; As I was saying it doesn't look like they used much of a bobbin for the field coil, not like a Magnavox one wou...Arran — 05:49 PM
Atwater-Kent 84, restoration.
This AK84 was bought, I think, last fall. For a whopping $100. It has been, according to the seller, restored. As I go ...morzh — 05:48 PM
Philco model 60
Plus I forgot that I have a spare complete Philco FC speaker, that would work perfectly, now that I don’t need it. Got i...Radios1340 — 05:36 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration